Raymarine ST60+ Wind

[sail4fun]

Recently installed one of the last available new Raymarine ST60+ Wind system. As of the first moment I switched on the system, the wind speed shows '0,0' no matter how fast the cups are turning.
Anyone a suggestion on how to solve this problem? Is it maybe possible to measure any currents/voltages at the bottom of the mast to find out what is wrong?
Thanks for helping out!

[transmitterdan]

Originally Posted by sail4fun

Recently installed one of the last available new Raymarine ST60+ Wind system. As of the first moment I switched on the system, the wind speed shows '0,0' no matter how fast the cups are turning.
Anyone a suggestion on how to solve this problem? Is it maybe possible to measure any currents/voltages at the bottom of the mast to find out what is wrong?
Thanks for helping out!

A little searching found this:

To perform a master reset you must hold
down the disp key and the true/app key
for 12 seconds. You will then hear 3 beeps
and dlr will be shown on the screen. You
now want to simultaneously press the vmg
key and tack key and release. You should
now see UC0 on the screen. Now press the
disp key 5 times until F0 is shown. Press the
vmg key once now F1 should be shown.
Lastly press disp key once. Your display is
now reset.

If the master reset doesn't work visit Raymarine Technical Forum and ask for assistance. The tech support guys over there are pretty helpful in my experience. Most likely it is a wiring error in the cables that come down from the masthead.

[jamhass]

if you go to the Raymarine tech forum and search there, you will find a set of test specifications giving the proper voltage ranges for all combinations of the wires coming from the masthead unit. Doing this test will help determine if the problem is in the sensor and cable or the readout. Sorry, my net is too slow to find the link right now.