B&G radar into Open CPN on raspberry

[Saintgeorge]

Hi everyone hoping someone can help with this .. I have openCPN running on a raspberry Pii 4, connected through boat WiFi to a Cerbo Gx running signal K. The Cerbo connects to my NMEA backbone so I get all the boat NMEA data that’s available on my Zeus 3 chartplotters , but the final piece I haven’t worked out yet is connecting the B&g 4g radar , does anyone know how to bring that data into my system ideally with the current setup!? Many thanks

[Sabado]

The raspberry Pi needs to be on the same ethernet network as the radar.

[Hakan]

Saintgeorge.
Normally wifi is not good enough to transfer the data size from a radar scanner. A hard wired connection is normally preferred.
You may like to read about radar plugin connections in the manual.