Cruisers Forum
 


Showing results 1 to 25 of 34
Search took 0.00 seconds.
Search: Posts Made By: PassportJoy
Forum: Navigation 04-09-2022, 08:26
Replies: 9
Views: 848
Posted By PassportJoy
Re: Anchor Question

I don't think there is a topic in boating that brings out more "opinions" than anchors and anchoring. I have had a challenging time anchoring in hard bottoms and hope sharpening the tip will help.
...
Forum: Navigation 04-09-2022, 07:44
Replies: 9
Views: 848
Posted By PassportJoy
Anchor Question

Has anyone "sharpened" the tip of their Delta Fast Set anchor. I have a 55LB Delta and wanted to improve its ability to penetrate the seabed.

Jeff on a Passport 43
Forum: Marine Electronics 15-08-2022, 04:16
Replies: 1
Views: 286
Posted By PassportJoy
M802 not tuning

M802 stopped tuning while sailing the west coast of Mexico. I have refreshed the counterpoise, replaced the gto15 wire, refreshed backstay attachment, ran new coax from radio to the tuner, installed...
Forum: Monohull Sailboats 09-04-2021, 19:26
Replies: 22
Views: 17,256
Posted By PassportJoy
Re: Passport Yacht Experience

If its like my 1999 43’ or the 80’s vintage 40’s the keel is lead
Forum: Marine Electronics 16-03-2021, 00:12
Replies: 3
Views: 506
Posted By PassportJoy
802 intermittent transmit

My 7 year old Icom M802 has consistently produced a great signal. Recently it refuses to transmit or even tune through the AT140. It will transmit at full power and then drop off to 0 bars on the...
Forum: Liveaboard's Forum 30-03-2020, 11:03
Replies: 105
Views: 14,596
Posted By PassportJoy
Re: Ruin My Dreams Please

Great planning and thinking your way through the complicated process. I commend you and although your numbers may change during the voyage, I say go for it. One piece of advice... buy your boat, live...
Forum: Anchoring & Mooring 27-03-2020, 14:00
Replies: 159
Views: 18,993
Posted By PassportJoy
Re: Marking your anchor location

I recently deployed small yellow fender attached to my anchor with a bungee cord. The fender remained directly above the anchor. It was interesting to see my boat in relation to my anchor as the...
Forum: Engines and Propulsion Systems 13-03-2020, 17:16
Replies: 172
Views: 31,675
Posted By PassportJoy
Re: Yanmar 4JH4-TE Catastrophic failure

I’ve seen it before... you hit something with your prop and it James, that caused your engine to instantly stop and the rod gave way... at least you have a new engine.
Forum: Anchoring & Mooring 29-02-2020, 19:54
Replies: 92
Views: 35,301
Posted By PassportJoy
Re: Comparing design of Delta and Sarca Excel anchors

Wow, If I come to Australia I better up my anchor game. Here in Mexico we don’t see those kind of winds except during the summer hurricane season. Most people put their boats on the hard or in a...
Forum: Anchoring & Mooring 29-02-2020, 18:06
Replies: 92
Views: 35,301
Posted By PassportJoy
Re: Comparing design of Delta and Sarca Excel anchors

It did hold last summer in 70 knots during hurricane Loraina but I wasn’t on the boat. If it’s going to blow 80 I’m going to set my big fortress out there as well. I would never rely on just one...
Forum: Anchoring & Mooring 28-02-2020, 14:35
Replies: 92
Views: 35,301
Posted By PassportJoy
Re: Comparing design of Delta and Sarca Excel anchors

Ok I used a Bruce (claw) on several boats for 15 years and although they seem to set a little slow (drag for about 20’ while setting) they always held me. 5 years ago I tried the Delta on a friends...
Forum: Destinations 11-02-2020, 01:28
Replies: 0
Views: 989
Posted By PassportJoy
Marinas and moorings in Acapulco

We are headed to Acapulco in late February 2020 and looking for your experience anchoring, mooring or going in to a marina in Acapulco. Acapulco Yacht club doesn’t seem to publish their guest rates....
Forum: Deck hardware: Rigging, Sails & Hoisting 04-06-2017, 17:42
Replies: 2
Views: 1,012
Posted By PassportJoy
Rust never sleeps

Thinking about rust on my stainless keeps me up at night... I decided to do something about it. I tried rubbing with "Never Dull" a cotton impregnated product. I rubbed and used a toothbrush in the...
Forum: Deck hardware: Rigging, Sails & Hoisting 25-03-2017, 19:31
Replies: 6
Views: 1,654
Posted By PassportJoy
Re: Passport 43 water in the gutter

UNCIVILIZED,

That is a great idea about extending the tube on a bevel to send the water off the topsides and I will defiantly take your advise. I am not sure if I can post a picture here but I...
Forum: Monohull Sailboats 25-03-2017, 16:52
Replies: 22
Views: 17,256
Posted By PassportJoy
Re: Passport Yacht Experience

I have a stunning 1999 Passport 43 that is often mistaken for a Hinkley. The boat is basically a Passport 40 with an upswept transom extension. They have a modified full keel with a slag hung rudder,...
Forum: Deck hardware: Rigging, Sails & Hoisting 25-03-2017, 16:36
Replies: 6
Views: 1,654
Posted By PassportJoy
Re: Passport 43 water in the gutter

Oh I neglected to say I will use a fiberglass tube as my "scupper" and glass it in on both ends.
Forum: Deck hardware: Rigging, Sails & Hoisting 25-03-2017, 16:34
Replies: 6
Views: 1,654
Posted By PassportJoy
Re: Passport 43 water in the gutter

I am in the process of drilling a 1" hole from the aft end of the gutter to outside of the hull. The nuisance water should flow out easily. I know the compromise is there will be a "watermark" down...
Forum: Electrical: Batteries, Generators & Solar 24-03-2017, 13:57
Replies: 3
Views: 7,794
Posted By PassportJoy
Re: Rutland 914i Problems

While my boat (and 914i) was parked in LaPaz Mexico last summer the "tie down" that held the blades from spinning came loose in 85 knots of wind. When I returned in the fall the 914i would not turn...
Forum: Marine Electronics 18-03-2017, 16:31
Replies: 66
Views: 9,401
Posted By PassportJoy
Re: AIS Transceiver in VHF

Vespar makes a splitter & AIS/VHF antenna. With it on the masthead my AIS reception and signal are much stronger than a rail mount AIS antenna.
Forum: Dollars & Cents 18-03-2017, 16:09
Replies: 65
Views: 12,287
Posted By PassportJoy
Re: Westmarine is insane

Buying from West makes good sense when you take into account the available extended warrantee and the ease of a return & replacement. Fresh water or wash down pumps are good examples. Their rigging...
Forum: General Classifieds (no boats) 10-02-2017, 10:36
Replies: 0
Views: 732
Posted By PassportJoy
Water Filter Cartridges

I have 34 - Pentek filters that I would like to sell. There are ninteen-50 micron filters, seven-20 micron and eight-5 micron filters These Pentek ECP-10" sediment filters fit standard 10" X 2 1/2"...
Forum: General Classifieds (no boats) 31-12-2016, 01:01
Replies: 12
Views: 2,937
Posted By PassportJoy
Re: For Sale - Fisher Panda 4kw Gen Set

Is it still for sale?

Jeff
Forum: Plumbing Systems and Fixtures 26-12-2016, 00:00
Replies: 33
Views: 6,796
Posted By PassportJoy
Re: Watermaker comparison worksheet

Let me be more clear for you. The essence of my comment is that a water maker is expensive and it's not just the up front cost. My Catalina 300 has a sea strainer, a 50 micron, a 20 micron and a 5...
Forum: Plumbing Systems and Fixtures 25-12-2016, 15:06
Replies: 33
Views: 6,796
Posted By PassportJoy
Re: Watermaker comparison worksheet

My 2 cents... 7 years ago I bought and installed a Spectra Catalina 300 MPC. I did the comparisons of amps vs GPH and this one beat everyone out there producing almost 1 gallon per amp hour. What I...
Forum: Deck hardware: Rigging, Sails & Hoisting 21-11-2016, 13:16
Replies: 6
Views: 1,654
Posted By PassportJoy
Passport 43 water in the gutter

I have a passport 43 that has the same deck layout as the Passport 40. There are two deck drains on each side that drain most of the water from the deck especially when the boat is flat. When water...
Showing results 1 to 25 of 34

 
Forum Jump


All times are GMT -7. The time now is 02:25.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.