kubota zl600 2 cylinder with cam driven bosch k type pump.
after 2 hours running under load engine
cut coming into the dock
when i reduced revs.
checked the oil
level,and it is right up the stick,suspect the injection pump is leaking for it to dump so much fuel
into the oil
just fitted this engine
which runs fine,starts fine, very little smoke and doesnt overheat.reasonable compression
it has no lift
pump,as it is gravity fed so not that.
no exsessive blow by from the breather.
any body had this type of problem from the bosch k type pump?
before i take it out thought i'd run it past the panel for opinions.
i did notice the exhaust
left an oily trail.