For Sale: LEWMAR 16ST & SELDON MOUNT

[Doug Brown]

For Sale:

One (1) Lewmar chrome 16ST self-tailing winch and one (1) Seldon #530-623 black anodize aluminum angled mast pad.

Winch is is good condition, just needs a clearing. It was purchased new and has just been mounted to the mast for 10+ years and was never used. It was for a mainsail reefing system. Turns freely, I took it apart today to remove it from the pad.

The Seldon mast pad is in good condition. Has the holes drilled for mounting the Lewmar 16ST. Has some bedding goo that needs to be removed, but in good condition. Uses six (6) 1/4 x 20 screws or 1/4" rivets to secure it to the mast.

$475 for both and I pay for the shipping to anywhere in the US.

[Doug Brown]

OK, LOWER Price

The Lewmar 16ST winch, the Seldon mast pad AND (drum roll here!) a Forspar 7/16" single line Clutch.

EVERYTHING for $415 and I pay shipping to anywhere in mainland US.

This is a real deal

Doug Brown

[antoha]

Doug,
If you are interested in parting this out: I'm only looking for a winch pad. Is it the 5 degree or 15 degree angle pad? Do you have photos? How much for just the pad? I need to angle my main halyard winch, halyard tends to cross on itself otherwise.
Thank you!
Anton



Sent from my iPhone using Cruisers Sailing Forum

[Doug Brown]

Hi - I'd rather just sell it as a package - however, I never turn down money!

Let me look up the info on the mast pad and I'll get back to you.

Are you going to use a Lewmar 16 as the winch - that is the bolt pattern of the holes, although you can drill whatever you need.

I'll get back to you in a bit.

Doug

[Doug Brown]

Anton -

As near as I can figure out the current part number for the
Seldon mast pad is: 523-041-01

The "base" for where the winch mounts is 110mm x 110mm (4.3" x 4.3")

Per their specs it has a 5-degree angle.

Current discount price is around $99.00

I can get a picture of it later on today.

If you are interested, how about $55 which will including shipping within the US?

Doug

[antoha]

Doug, thank you. I think it will be too small for me (I have an Andersen 28 ST on this halyard).
Anton



Sent from my iPhone using Cruisers Sailing Forum

[antoha]

Originally Posted by antoha

Doug, thank you. I think it will be too small for me (I have an Andersen 28 ST on this halyard).
Anton



Sent from my iPhone using Cruisers Sailing Forum

Although you did mention lewmar 16 currently installed, which should correspond to the next size up pad. Can you please measure the pad's dims? And a picture would be helpful too.
Thanks again!


Sent from my iPhone using Cruisers Sailing Forum