Visit our Popular Forums

Wingsn1 · 31-03-2021, 12:46

For Sale : Robert Harris 38' foam core Trimaran
Location : Yarmouth , Maine
Email : wingsn1@protonmail.com
*** ASKING $26,000 OBO ***

All hulls are in great condition, made of Airex foam core weighing 8500 pounds
Canted amas
7 Sails - Like New
Rigging is solid
The deck pod has 360 degree visibility while sitting and is completely protected with a dodger.
Wheel also has a locking function and is set-up for an autopilot
Cheap launch available

Survey (/w previous posting) : https://www.cruisersforum.com/forums...fs-109208.html

Things we did in 2019
Applied epoxy paint + nonskid over all decks together with fresh antifoul paint
Installed new memory foam cushions on all bunks and new Queen size bed in aft cabin
Fresh interior paint
Removed the head to be replaced with compost toilet,
Purchased lithium battery + 200W flexible solar panels + charge controller + inverter all ready to install
Purchased a 9.9 Honda electric start outboard, ready to mount

Pictures : https://postimg.cc/gallery/Hmbc2Lc
Youtube video of the interior:

https://www.youtube.com/watch?v=PTWyqnm4JCw

sailrjim · 02-04-2021, 21:32

[QUOTE=Wingsn1;3377630]For Sale : Robert Harris 38' foam core Trimaran
Location : Yarmouth , Maine
Email : wingsn1@protonmail.com
*** ASKING $26,000 OBO ***

All hulls are in great condition, made of Airex foam core weighing 8500 pounds

Greetings Multihuller,
Some questions please:
1. can you advise what is the sheave box imbeded in the deck/cabin top near mast foot, starboard side? For dagger board/CB/lifting keel?
2. What are the metal objects attached to the aft edges of the forward aka, near the shroud chainplates?
3. What are the bolt heads/nuts/bolt ends that appear in the akas approx. four places? Not sure what I see there (resolution).
4. The referenced survey mentions several items to check/repair: rod thru aka welded to chainplate which I do not see in photos, crack in bulkhead near aka, and several other items. It would be helpful if you could address these for the forum.
5. What is the draft min./max of Wings?
6. What is the payload capability? Is the weight figure the loaded displacement or the "light displacement"?
7. No diesel in crate as offered previously? Did you plug the shaft log?
I would see for myself, but I do not own an airplane and it is a longish drive from VA.

TIA,
Jim

Chotu · 03-04-2021, 02:29

**Should be added to the “recent noteworthy finds under $30,000” thread.

dano098 · 03-04-2021, 09:33

Wingsn1 is seller/OP

mattyc · 07-04-2021, 10:14

Good questions waiting to be answered. Where is the OP?

Chotu · 07-04-2021, 10:43

Quote:

Originally Posted by mattyc

Good questions waiting to be answered. Where is the OP?

Probably cashing his check already. LOL. That was one hell of a boat and deal.

Wingsn1 · 07-04-2021, 18:00

The boat is still available.
To answer some of your questions,

Quote:

Originally Posted by sailrjim

1. can you advise what is the sheave box imbeded in the deck/cabin top near mast foot, starboard side? For dagger board/CB/lifting keel?
2. What are the metal objects attached to the aft edges of the forward aka, near the shroud chainplates?
3. What are the bolt heads/nuts/bolt ends that appear in the akas approx. four places? Not sure what I see there (resolution)

From the survey : The forward aka had stainless rods welded to chainplates, through the aka with a link plate, tightened with nuts over the top.
Originally the boat was thought out to be demountable however it has been fiberglassed over , the rods add additional support but are not load bearing or necessary.

4. The referenced survey mentions several items to check/repair: rod thru aka welded to chainplate which I do not see in photos, crack in bulkhead near aka, and several other items. It would be helpful if you could address these for the forum.

The rod as mentioned above is not load bearing. I haven't found a crack in the bulkhead or any other structural damage, just little tasks that need to be finished as every other boat.

5. What is the draft min./max of Wings?

3'6" , found in the survey.

6. What is the payload capability? Is the weight figure the loaded displacement or the "light displacement"?

The survey doesn't say however I'd say its in the cruising trimaran range due to the hull shape.

7. No diesel in crate as offered previously? Did you plug the shaft log?
I would see for myself, but I do not own an airplane and it is a longish drive from VA.

The new inboard diesel is in the shop & can be installed , however the boat was purchased without it being included. Shaft is still on.

TIA,
Jim

Let me know if you have any more questions , happy to answer!
~

sailrjim · 08-04-2021, 21:33

Quote:

Originally Posted by Wingsn1

The boat is still available.
To answer some of your questions,

Let me know if you have any more questions , happy to answer!
~

Thanks for the response.
I had previously read the survey, but saw no mention of the sheave box mentioned in my question number 1. It is not obvious to me the purpose, though I can think of several possibilities. Was thinking that perhaps it was for a dagger board that had been removed or for under deck leads for halyards, or for multipurchase halyards. I see line still going to the sheave box, so still in use? Inquiring minds want to know.
TIA,
Jim

Wingsn1 · 09-04-2021, 00:07

Hi Jim , I missed this one.
The sheave box is for the centerboard.

mattyc · 13-04-2021, 10:19

Sent you a Private Message

Wingsn1 · 21-04-2021, 22:04

Price Reduced to 24,000$ USD for a quick sale

Chotu · 21-04-2021, 23:21

Someone hurry up and buy this boat before I do! Ha ha.

Wingsn1: make sure you are listing on sailboatlistings.com and the following places:

https://www.google.com/search?q=sail...obile&ie=UTF-8

Also, spring is only just popping. A little patience to May/June when the boat market starts back up in New England.

The boat market is still red hot.