Howdy,
I've just installed my brand new shiny Xantrex LinkPro and quite simply, it doesn't do anything.
...having said that I wired it
almost exactly per the diagram in the install guide...
By way of explanation - everything is exactly per the diagram -
except the + and -, which are described as being the "positive supply voltage" and "negative supply voltage" respectively. With these descriptions, I think of these as "power supply" - and wired them into my "instrumentation" circuit.
I have checked that I have 12VDC and GND at these terminals at the back of the LinkPro, but have absolutely nothing on the
screen.
Is there some magic to
wiring the + to directly to the
battery and the - to the load side of the shunt? I understand that they might be used as
references internally, but surely it would result in an incorrect reading as opposed to absolutely
nothing right?
Thank you in advance and looking forward to any light shed in this direction...
//AK.