|
|
13-08-2021, 06:56
|
#31
|
Registered User
Join Date: Jun 2011
Location: Ontario, Canada
Boat: C&C 44
Posts: 37
|
Re: Cleaning grimy shore power cable
Sailingveteirnarian has it right. Marine strip is a paint remover that also works very well and is recommended for cleaning power cables and fenders. Available at Boat Owners Warehouse, in Florida or direct from the manufacturer. Use a WHITE rag and a 3M scrub pad. Avoid acetone at all cost, it will make your problem worse.
|
|
|
13-08-2021, 06:57
|
#32
|
Registered User
Join Date: Jan 2010
Location: Lower Chesapeake Bay
Boat: Columbia 9.6 meter
Posts: 84
|
Re: Cleaning grimy shore power cable
Quote:
Originally Posted by sailing_gal
Fast Orange- that stuff that they sell in hardware and autoparts stores works great on plastics and doesn't damage them. I use it to clean my dinghy, fenders, anything plastic. You can just rub it on with your hand. Cheap and harmless and amazingly effective.
|
That Fast Orange works well, has limonene as its solvent.
If Fast Orange doesn't cut it, you might try MEK before Acetone, simply because MEK doesn't evaporate as fast as Acetone, so can work on the surface. MEK is a strong solvent, and toxic like Acetone.
Either way you go, glove your hands with medium nitrile gloves for either solvent, the chemicals will defat the epidermis and cause skin damage.
A possible probable cause of the crusty film on the sheath of the cable is that the plasticizer is leaving the plastic, which portends that the plastic will become increasingly brittle.
Time will tell, everything ages.
Cheers ~ 9.6
|
|
|
13-08-2021, 07:00
|
#34
|
Sponsoring Vendor
Join Date: May 2015
Location: Fairfield CT
Boat: C&C 33 MKII
Posts: 123
|
Re: Cleaning grimy shore power cable
My Cable was really bad from the previous owner. I just used Clorox Clean up and a Gritty sponge. Results were spectacular. Will never look new again, no matter what you use, but it is not greasy and brown, but a bright yellow
|
|
|
13-08-2021, 07:02
|
#35
|
Registered User
Join Date: May 2011
Posts: 149
|
Re: Cleaning grimy shore power cable
Quote:
Originally Posted by boatman61
Just spend the $40 for a new cable.. if the plugs are not moulded remove and fit to a length of appropriate cable for less cost.
The type of cable one use's for electric garden tools outdoors is perfectly adequate.
A bottle of Starbrite dinghy and fender cleaner is gonna set you back $19 so just bite the bullet now and replace the cable.
|
This was my thought too... although... where are you getting $40 shore cables?!?! Up here, they are $120 - $170 depending on length.
The way I figure it, the amount of time to clean a 30' or 50' shore power cable + the cost of cleaning materials + aggravation of having to do it again in one or two years... I would look seriously hard at all of that to see if it's more expensive than just buying a new one. At $40, it's a no brainer to buy a new cord. At $170... well... I might see if I could extend its life.
|
|
|
13-08-2021, 07:04
|
#36
|
Registered User
Join Date: Jan 2011
Location: Caribbean live aboard
Boat: Camper & Nicholson58 Ketch - ROXY Traverse City, Michigan No.668283
Posts: 6,376
|
Re: Cleaning grimy shore power cable
I was prepared to ignore this thread until I saw the acetone, MEK suggestions.
Please no.
These are strong solvents. While they may make short work of grime they also strip the plasticizers out of the PVC cover. This makes them brittle and seriously shortens life.
If ours get in greasy stuff I might use mineral spirits but the Agent Orange suggestion is great, preferred. Ordinary liquid soap undiluted is also good.
We normally use nothing but a damp rag and wipe off surface dirt. It doesn’t really matter what the outside looks like. The electrons don’t care.
|
|
|
13-08-2021, 07:06
|
#37
|
Registered User
Join Date: Oct 2017
Location: CPYC Erie, PA
Boat: Catalina 34ll 2001
Posts: 40
|
Re: Cleaning grimy shore power cable
For fenders and shore power cords I go with Don Casey's recommendation of paint brush cleaner. The old stuff not designed for water base paint. I've had good luck with it but things need to be recleaned every couple of seasons.
|
|
|
13-08-2021, 07:07
|
#38
|
Registered User
Join Date: Jan 2011
Location: Caribbean live aboard
Boat: Camper & Nicholson58 Ketch - ROXY Traverse City, Michigan No.668283
Posts: 6,376
|
Re: Cleaning grimy shore power cable
Quote:
Originally Posted by JordanH
This was my thought too... although... where are you getting $40 shore cables?!?! Up here, they are $120 - $170 depending on length.
The way I figure it, the amount of time to clean a 30' or 50' shore power cable + the cost of cleaning materials + aggravation of having to do it again in one or two years... I would look seriously hard at all of that to see if it's more expensive than just buying a new one. At $40, it's a no brainer to buy a new cord. At $170... well... I might see if I could extend its life.
|
Have you $hopped for the$e lately? $tay away from We$t Marine.
|
|
|
13-08-2021, 07:39
|
#39
|
Registered User
Join Date: Feb 2008
Location: North Charleston, SC
Boat: Camano Troll
Posts: 5,176
|
Re: Cleaning grimy shore power cable
Quote:
Originally Posted by boatman61
..............
The type of cable one use's for electric garden tools outdoors is perfectly adequate.
.
|
If you are thinking of following this advice, please don't!
Your shore power cable needs to be made of the gauge (diameter) of wire rated to carry the expected current. That would be #10 for a 30 amp cord and #6 for a 50 amp cord. It also needs to stand up to temperature, weather, oil and grease and other conditions. It also needs a certain flexibility.
If you think it's a good idea to make up your own shorepower cord, I would strongly suggest buying cable intended for marine shore power cables and connectors intended for use as shore power connectors.
I believe that you will find that the parts purchased separately will cost as much or more than an assembled shorepower cable with molded, waterproof ends, something that you cannot duplicate with separate parts.
Bottom line is, the electricity doesn't care if the cable is dirty or not so if you cannot clean it without damaging it (acetone, solvents, etc.), your choice is to either continuing to use it as it is or replace it with a new, store bought cord.
__________________
Ron
HIGH COTTON
|
|
|
13-08-2021, 07:56
|
#40
|
Registered User
Join Date: Feb 2015
Location: Texas
Boat: C&C 41
Posts: 32
|
Re: Cleaning grimy shore power cable
Z cleaner has worked for me.
|
|
|
13-08-2021, 08:17
|
#41
|
Registered User
Join Date: Jul 2014
Location: Pensacola, FL
Boat: C Dory 25 foot semi dory pilot house power boat
Posts: 101
|
Re: Cleaning grimy shore power cable
303® AEROSPACE PROTECTANT is essential for longevity of the yellow power cords and fenders after cleaning.
Clean with the citrus based hand cleaners, a Scotch Brite pad if necessary, Finish wash with a little Dawn and then dry. Apply the 303. Let it sit for a couple of hours and then wipe off any excess. The 303 (with UV protection) helps to maintain the surface plasticizers. Apply every month, and wash the cord if necessary between with soap and water...
|
|
|
13-08-2021, 08:43
|
#42
|
Registered User
Join Date: Sep 2009
Posts: 196
|
Re: Cleaning grimy shore power cable
Dollar Store lavatory cleaner. Wear rubber gloves and don't get it in your eyes (or mouth) Finish with wash in fresh water (or salt water if fresh not to hand)
|
|
|
13-08-2021, 08:55
|
#43
|
Registered User
Join Date: May 2011
Posts: 149
|
Re: Cleaning grimy shore power cable
Quote:
Originally Posted by Nicholson58
Have you $hopped for the$e lately? $tay away from We$t Marine.
|
Yes... Binnacle is my go-to shop and they are amazing. Like I said though, a new cord there is $120-$170cad. That's what... $96-$136usd. For some yachties, that's the price of a meal. For others, that's half a year's boat budget.
I'm just staying, if you're going to spend a beautiful day, scrubbing a cord, inch by inch... is it really worth it? You'll need to do it again next year.
|
|
|
13-08-2021, 10:47
|
#44
|
Registered User
Join Date: Jan 2017
Posts: 9
|
Re: Cleaning grimy shore power cable
Try Purple power degreaser, incredible stuff Cleans my fenders. Does not damage the finish.
|
|
|
13-08-2021, 10:51
|
#45
|
Registered User
Join Date: Apr 2008
Location: Pacific Coast
Boat: Lancer 27PS
Posts: 2
|
Re: Cleaning grimy shore power cable
Quote:
Originally Posted by BozSail
What's a good cleaning agent to remove builtup grime from a disgusting looking shore power cable? Regular boat soap doesn't seem to do it... lots of scrubbing and very poor result.
|
209 will do the job. Actually any cleaner with a beuttle (sp?) cleaner will do. It has a distinctive odor and once you smell it you can always tell if a cleaner has it in the mix...
|
|
|
|
|
Thread Tools |
Search this Thread |
|
|
Display Modes |
Rate This Thread |
Linear Mode
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
Advertise Here
Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
Vendor Spotlight |
|
|
|
|
|