Hello,
I have installed an YDEG-04
engine gateways for two
Volvo D2-40 and they both
work great. However, I have difficulties to decode the data log.
Following the example in the manual, I recognized the ID in the ID(hex) column (last two digits), sorted the data by time, then converted D1 and D2 into a decimal value.
According to the
NMEA log there are five different variables:
engine speed (rpm), engine temperature, total engine hours, engine status 1 and 2. Since there was never an engine status (error message) reported, I ended up with three separate ID's for each engine, just as expected. However, converting the D1 and D2 bit provides no recognizable pattern or any kind of recognizable data.
I used the same method on the sample
Volvo XC90 data provided with the CAN log
software and it seems to
work well.
Any recommendations?
Thanks, Tom