Raymarine E120 Rebooting

[kenrobmac]

We have a Raymarine E120 which was working fine until yesterday. Yesterday after working for about 4 hours it started to switch off and then automatically reboot with the factory settings. This was happening about every 5 minutes.
I have tried a system reset but I have now lost AIS and the course vector.
This 5 minute reboot is continuing even with the factory settings.
Any suggestions would be welcome.

[smac999]

Disconnect all cables except the power. And pull out chart cards. See what happens. Put one back in at time to to find issue.

If it does it with just power then unit is Likly dead.

Ais is Likly Port from setting back to default 4800. Change to 38,400

[BocaIII]

Originally Posted by smac999

Disconnect all cables except the power. And pull out chart cards. See what happens. Put one back in at time to to find issue.

If it does it with just power then unit is Likly dead.

Ais is Likly Port from setting back to default 4800. Change to 38,400

Good suggestions….also, make sure you have min 12.5 v on the MFD
The e & c series are very low voltage sensitive
Good luck
Jack
Raymarine field beta tester

[GreenWave]

And make sure your voltage to the unit is not only meeting the minimum but is stable. A bad power cable/connection could cause the reboots.