Considering fitting a
teak rubbing strake to Moonshines pretty flanks. Partly a cosmetic exercise but a bit of extra protection should anything get past the fenders.... Either 25mm sq or possible 32mm sq.
Anyhow, how best to fit
teak rubbing strake to FG
hull???
I reckon from experience that a good
sealant ( Sikaflex ) will do all the bonding that is required? So I am hoping to use minimal number of self tappers primarily to hold in place while
sealant sets. As in 1 self tapper per meter or so...
Any critique of this scheme would be very welcome!
Mark