Greetings:
I am nearing the end of a three year
rebuild of a Rhodes 32. The
boat has cabinet doors with hinges that pull apart when you open the door and then
lift and wiggle the door up. The
boat was built in
Denmark, maybe the hinges were too..??
Anyway, I would like to reuse these hinges and am not sure the best way to install them in the new cabinets I built. The cabinet portion of the hinge sits in a 1/16" or so slit in the face of the cabinet. How do I create this dado of sorts for the hinge (router, drill?) any ideas?
Also, I cannot tell how the cabinet portion of the hinge stays in place. There does not seem to be any
hardware. Could they just pressure fit in place?
Thanks
Christian