I'm currently
wiring up my Xantrex Linklite and I'm not 100% sure how to wire up a relay to the
alarm output.
There are two terminals for the
alarm, A1 and A2. Do I wire up the relay to each of these terminals?
I assume this to be the case, as the Linklite only has one alarm, but looking at the
installation instructions for the Linkpro which has two alarm outputs it still only has an A1 and A2 terminal?
So maybe on the Linklite, the A1 terminal goes to the relay, then from the relay to the negative bus. And A2 is not used on the Linklite?