| External Link Notice |
Page Information:
|
Page Title:
1969 Chris Craft Roamer 46 Refit: Cummins Engine Install — Coating the Stringers & Final Fit « 1969chriscraftroamer46
Page Description:
With the vibration isolator landing pads done and motor mounts modified, the last step to getting this engine resting in its ultimate location is to epoxy coat the stringers and do the final alignment. After the last test fitting, once I had the gear and shaft couplers aligned to within 0.005", I marked the holes…
This Page is About:
|
|
NOTICE: By following the "Continue to External Link" above you will be leaving Cruisers & Sailing Forums web site and entering a web site hosted by another party. Cruisers & Sailing Forums does not have any responsibility for, or control over, any of these sites, their content or their privacy policies. We do not endorse or make any representations about them, or any information, products, or materials found there, or any results that may be obtained from using them. If you decide to access any of the linked third parties, you do so entirely at your own risk.
|
|
All times are GMT -7. The time now is 01:01.
