|
Click Here to Login |
Community Links |
Social Groups |
Pictures & Albums |
Members List |
Meet the Mods |
Meet the Advisors |
Signup for The Daily Cruiser Email |
Search Forums | |||||
Tag Search | |||||
Advanced Search |
Showing results 1 to 15 of 15
Search took 0.00 seconds. Search: Posts Made By: Paul Elliott |
Forum: Marine Electronics 11-01-2014, 11:29 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
This is an interesting idea, so I did some math. I don't think this will work: A modern high-efficiency LED anchor or tricolor light draws about 0.1A @ 12V. To power this for 12 hours would... |
Forum: Marine Electronics 27-12-2013, 16:57 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
I would think that a gimbal mount would be good, since it should keep the antenna level too (make sure that the added weight doesn't upset the balance). You probably aren't going to use a high-gain... |
Forum: Marine Electronics 27-12-2013, 10:36 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
rgleason, I don't think there is a single "preferred" way to mount the AIS antenna. Generally, higher is better, although with a stern-rail mount you will still probably get reasonable AIS reception... |
Forum: Marine Electronics 26-12-2013, 22:07 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
Thanks Matt, As you have probably seen, I have PM'd you with a request for clarification (from Optolamp). Their answer is good, and yours is great, but there are to my mind unanswered questions. ... |
Forum: Marine Electronics 24-12-2013, 19:54 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
I searched that, and while there were some mentions of testing and "no noise detected", I can't tell how these test were done. Not to discount these tests (well I guess I am doing just that), unless... |
Forum: Marine Electronics 24-12-2013, 17:38 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
Evans, who besides myself has done these noise analyzer measurements? (this thread or elsewhere?) I just scanned this thread from the beginning and didn't see anyone using test equipment, or... |
Forum: Marine Electronics 24-12-2013, 17:11 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
You're right about this. Casual testing is just that, and if one person's VHF antenna is a few inches closer/farther/higher/lower, that person's "OK" is another's "Fail". I used to do this kind... |
Forum: Marine Electronics 24-12-2013, 11:50 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
100%? Of course not. To give you that I would want to use a calibrated antenna / preamp / etc, so I could compare the measurements to the receiver sensitivity. Even then, my personal analytic... |
Forum: Marine Electronics 24-12-2013, 09:55 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
The Optolamp "Amazonia" tri/anchor/strobe has caused no interference to my VHF or SSB radios (I discussed my measurements a few posts previously). Apparently the Lopolight is also quiet. So not all... |
Forum: Marine Electronics 15-12-2013, 18:42 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
Today I connected the spectrum analyzer to the masthead VHF antenna, and I could not measure *any* VHF interference. I looked at the entire marine VHF band, and for greater sensitivity did a... |
Forum: Marine Electronics 13-12-2013, 18:40 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
Be aware that the tri/anchor/strobe functions are controlled by three wires. The tri/anchor mode depends on the 12V/Ground polarity on one wire pair, and the strobe runs when the third wire is... |
Forum: Marine Electronics 12-12-2013, 17:24 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
Remember that we are also discussing masthead tricolor lights. Yes, I know we could use deck-level lights, but I want my tricolor. I have an Optolamp "Amazonia" tricolor, with an adjacant VHF... |
Forum: Marine Electronics 11-12-2013, 21:54 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
Here are some EMI tests done by OGM, showing improvements to the emissions from one of their LED navlights: https://www.cruisersforum.com/forums/attachment.php?attachmentid=71964&stc=1&d=1386826510 ... |
Forum: Marine Electronics 10-12-2013, 08:41 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
I know this is old information, but it's also a crap excuse. Some radios may (perhaps) be more susceptable to certain out of band noise, but this really isn't a radio problem. |
Forum: Marine Electronics 10-12-2013, 08:36 |
Replies: 97
Views: 18,635
Posted By
Paul Elliott
Re: LED Noise?
zboss, I don't know if there is a reasonable solution, but I will be interested to see if other folks are having RFI issues with their OGM lights. How close is your antenna to the OGM light? Both... |
Showing results 1 to 15 of 15 |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc. |
Privacy Guaranteed - your email is never shared with anyone, opt out any time.