Cruisers & Sailing Forums - Search Results

		Cruisers & Sailing Forums > Search Forums
Search Results

Vendors

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: delmarrey

Forum: Construction, Maintenance & Refit

11-11-2010, 21:12

Replies: 32

Advice on Pulling Off the Cutlass Bearing . . .

Views: 8,114

Posted By delmarrey

Here are the set screws for crushing the bearings...

Here are the set screws for crushing the bearings after splitting them. Even if the bearing were glued in it would make since to still spit the bearing. Where would one find this heat sensitive glue?...

Forum: Construction, Maintenance & Refit

13-10-2010, 20:00

Replies: 32

Advice on Pulling Off the Cutlass Bearing . . .

Views: 8,114

Posted By delmarrey

One other thing I should have mentioned. Another...

One other thing I should have mentioned. Another purpose for the set screws are if one splits the bearing from the inside with a hacksaw blade close to the set screws. Then one can tighten the set...

Forum: Construction, Maintenance & Refit

11-10-2010, 21:19

Replies: 32

Advice on Pulling Off the Cutlass Bearing . . .

Views: 8,114

Posted By delmarrey

FYI-This is done when the bore of the strut...

FYI-This is done when the bore of the strut (P-bracket) has been eroded enough that the bearing doesn't press in any more but slides in. If it's an EZ slide (by hand) then start looking at a...

Forum: Construction, Maintenance & Refit

11-10-2010, 20:48

Replies: 32

Advice on Pulling Off the Cutlass Bearing . . .

Views: 8,114

Posted By delmarrey

Ditto!!! That's why they have insurance!

Ditto!!! That's why they have insurance!

Showing results 1 to 4 of 4