- What would you call this...
- Zincs and Bonding
- Bilge Covering Board Fastening Method?
- Optimum Sunbrella thread type
- Deck Core Soft Spot? -a Low Budget Amateur Repair
- Confused about bottom painting dinghy
- replacing fixed portlights - painting acrylic
- 1GM10 Parts
- Acrilic set in teak hatches
- Freya 39 Rudder removal?
- Bringing Teak Cabin Floor Back to Life???
- Rusting already
- Houdini hatch leaking
- houdini hatch leaking
- Winch advice…..Barlow 15
- Advice for Work / Service on Lagoon 410 in St. Martin
- How to find parts for fabrication? Yanmar DIY generator
- Any Portable Workbench Recommendations?
- Non-Skid Varnish
- Waterline
- Port Light Parts for 1965 Pearson Alberg
- I hate Steering Wheels
- LED Spreader Light Refit
- Best adhesive? centerboard seal on a small boat.
- Refit of our Dufour
- wrench/spanner query
- Rudder shaft
- Islander 36 Keel Bolts
- marine salvage, scrap yards
- Remodeling Lagoon Cabin -- ideas?
- Blister pics for Minaret
- Combining bottom paint
- Non-Skid on fibreglass deck
- davit motivication--need ideas
- Stern Tube Leakage
- Boat Yard advice
- Advice needed on FOAM cushions and V berth mattress!
- Rudder inspection service?
- Varnish (Cetol) - Gelcoat Interface
- Transparent Sailboat
- Restoring a FC sailboat- underbody with cpesp
- foredeck hatch HELP
- Refinish teak over Awlgrip
- Best dewaxer/degreaser for hull topside prep?
- Gotta Love Being on the Hard
- Raw water AC system
- deflate dinghy ?
- Clean and Anti Foul Fiberglass Hull (Cairns)
- My new Boat and fixing question
- 28 Years Old and Still Shines!
- CAL 39 rudder zinc location
- Hydraulic Steering Questions
- R-12 to R-134 change
- Ecotech Watermaker
- How to attach SS strip to rubrail???
- Thrugh-hull drill size
- Chandlery/online Europe
- Old boom, new outhaul.
- Seperate engine bilge from rest
- Nav Station Design Ideas
- How to treat this bow sprit?
- True Rigger
- TruDesign composite seacocks?
- Cabin sides lining
- Re-Painting a Windlass
- A blank canvas
- Securing prop shaft after engine removal
- Mounting Stainless Steel Plate on Transom
- Temp sender source
- Removing cabin liner?
- Anti seize on thru hull
- Help removing Beneteau 423 ceiling panel
- Fajardo Refit
- Blue VC-17 in fresh water?
- bottom paint vs. launch date
- Advice on a couple of things
- DIY Diesel Polishing
- Rudder design for Excalibur 36
- Fuel tank leak- advice needed
- Bedding Compounds
- Epoxy fairing of hull
- Alberg 30, Project or Landfill?
- Stains Bleeding through Paint
- Maintaining a Timber Boat
- Steel sail boat.
- Chainplate leaks
- arch...430....wind generator
- Hull Repaint Options Soling 27
- anyone recognize this skiff?
- Taylor 030
- Cheoy Lee Traveler Winch
- Saloon table pedestal - adjustable height
- Chainplate's isn't mounted right. Is it still OK to sail?
- Wood glue for flexible panel
- beveled edge alternative for fiberglass layup
- Weights in the bilge
- Fiberglass mold- get a glass smooth surface?
- Brazilian Cherry Hardwood Flooring
- Don Casey
- Confused on bottom painting...
- Douglas Fir Boom Question
- Interior layout...why?
- Need Advice on Stress Cracks
- Hull blisters. Repair or leave alone?
- How do I access the swing keel lift system on Jeanneau 24.1 ?
- Force 10 heater tank?
- Skin fittings and sea cocks
- Maintaining a 45' Cutter Rigged ketch
- Prevent Rust on Rail Straps
- Headlining replacement
- Portlights in a cored hull
- Electrical Guestimates
- Bimini - problem finding right one
- Hull/Keel Maintenance Advice for Newbie
- Jeanneau 54DS Fluxgate Compass
- Bermuda Boat Yard Recommendations
- Replacing Diesel Tank
- What Torque to Tension Chainplate Bolts?
- Advice on DIY fibreglass holding tank
- Painting Verses Vinyl Wrapping
- Looking for a couple used bronze cleats
- Aluminum LPG tank Placement
- Caclulating hull strength WRT chain plates
- Anchor Rode: Re-Galvanize or Throw Away?
- Lifting a boat, sans Crane
- SUGRU redux
- refrigeration
- removing portlights on a 30 yo Hinckley
- Wind vane self steering transom hung rudder
- wood on coaming tops, bad idea? how install?
- Gluvit paint on frp deck job
- Anyone know a good woodworker in the Ionian
- Tanker 26 berths
- Scuppers exit at waterline - no seacock
- Bottom painting in the rain
- Boat name
- Zincs
- sound insulation ideas?
- installing mast track
- Fairing Compund?
- Fuel Tank/Water Tank Cleaning
- ABC Bottom paint
- Epoxy Resin Guesstimate Request!
- Hello all. Great Forum. I have a keel issue after grounding
- What is This on the Teak Wood?
- Bolts on rudder under waterline
- Full enclosure worth it in the tropics?
- Cascade 36 Blister Potential?
- Filling Void in Rudder Shaft
- Aluminum Bimini and Dodger
- Upholstery Unthreading
- Awlgrip bottom paint - never been in since painted 6 years ago. Is it compromised?
- ERPS (Electronic Rust Prevention System)
- Rudder Repair
- Monel screw
- How to access area below deck stepped Catalina 30 mast
- Anyone Pull their own Masts?
- Pedestal Steering Clunk!
- Watch outs
- Awlgrip's Awlwash?
- Stored Shelf Life of Anti-Fouling Paint
- Latex Foam durability
- Composite Carbon Fiber Chainplates
- Polyester Flowcoat stick to Epoxy?
- New Deck for Coronado 41
- Looking for advice on companionway
- Best Non Skid For Longevity??
- Dyer Dinghy rub rail replacement
- Spray-on coatings?
- polishing stainless steel
- 3M Blue tape impossible to remove
- Free Chartplotter (or why we love projects)
- Dingy floor - Varnish or Urethane?
- What do you consider a requirement?
- Removing fixed port frames
- Can gelcoat be skipped?
- Gates Powergrip Hose Clamps
- Help with Exterior Teak issue
- Aluminum mast corrosion repair
- Does sea water in the bilge cause osmosis?
- seamless versus welded tubing
- Swing Keel Corrosion
- Bulkheads... How 'bout using some 3/4" Red-Oak?
- Mainsail Flaking Systems
- Thing attached to overhead
- Keel joint rust?
- Hydraulic ram leaking ..
- Question about hull coating
- Fiberglass Repair, Gelcoat, Color Matching and Dummies
- General Repower Questions
- Repairing Termite Damage to Wooden Masts
- wilcox crittended
- re-bed Hatches
- Yacht Specialties Pedestal Brake
- Another game of "What is it."
- Refitting Videos?
- Companionway Instrument Support Base Refit
- Windvane choice for Benetteau 42 CC
- Replacing my hatch - plastic, metal?
- Slide Gate
- Hatch Reinforcement
- Most nontoxic Cheapest paint-strip for boat deck
- Best Manual Head?
- I got the leakin fuel tank blues...
- Flexing Flexible Wet Exhaust Tubing?
- Lonseal flooring adhesive
- Fuel tank monitoring system
- boarding ladders
- Bottom Pait Stains and Particals
- Make a new rudder
- Cleaning Copper Cladding
- Baja Naval Boatyard
- Blistering AFTER barrier coat application!
- Size of Propane Locker?
- Cockpit Sole Repair
- Water Damage Repair
- Casting anodes
- Long rubber propane lines okay?
- Hauling 30 sailboat near San Diego
- New lines
- Protecting the deck from the anchor
- Leaking Hull
- Adding Second Boot Stripe Over Bottom Paint
- Teak Decks Fastened from Inside Cabin
- New ideas on old silicone?
- New ideas for replacing headliner?
- Glass window bonding question
- Sealing Plywood before Applying Epoxy
- Icemaker broken wonder why
- Waterproof catches -horizontal
- Osmosis Question
- Cheapest place to buy ARMAFLEX sheet insulation?
- cabin top leveling block for stove exhaust stack
- my buddy didn't winterize
- Polyurethane on spars, one part, two part?
- Engine refit
- Truck Bed Liner
- Bad MacGyvering ! Questionable Funny Repairs
- Winch overhaul
- Window, from scratch
- Raritan PH II
- Seacock backing plate yes/no?
- Blisters, again
- EPoxy or paint?
- Leaky Stanchion Base Repair
- Online Maintenance Log
- SolidWorks Anyone?
- Going up the mast while on the hard?
- Nauticat 40/43
- Folding bulkhead table design ideas