Cutless bearing size on 1973 Morgan OI 41 with 1.25" shaft

[Paul M]

Hi all,

Does anyone happen to know the OD for the above cutless bearing?

Also, any advice on removing the old one would be greatly appreciated.

Cheers,

Paul

[Suijin]

Easiest extraction would be with a cutless puller. Perhaps the yard where you are at will let you borrow theirs. On an OI pulling the shaft will make the job easier and may even be necessary.

I would pull the old one and measure it. Or put calipers to it if enough of it is exposed.