Hello, me again re the Morgan 31
rigging. I am now wanting to lead the topping
lift and main
halyard aft to a
winch in the
cockpit. The
winch is currently attached to the mast. Problem is that my boat has a raised section about 15"x15" all around the mast foot, probably 2" high. and as wide.
I need advise as to where the lower blocks from the mast foot as well as the organizer must be to get the lines "over" this raised section.
The easiest would probably be to drill holes through the base of the raised section but I would hate doing that, not knowing what problems I may run into.
Kindly advise how your bout is rigged in this area - perhaps with some photos if possible.
Thanks. Jack