Cruisers Forum
 


Join CruisersForum Today

Showing results 1 to 22 of 22
Search took 0.01 seconds.
Search: Posts Made By: TEV
Forum: Plumbing Systems and Fixtures 11-06-2020, 13:00
Replies: 172
Views: 60,332
Posted By TEV
Re: PUR / Katadyn Watermaker Help from an Ex-Cruiser

Update, per Katadyn tech the amp draw is right in spec for new motor with gearbox and no pump attached, so these oldies will go back online. They have been very helpful sent me their full manual...
Forum: Plumbing Systems and Fixtures 10-06-2020, 14:40
Replies: 172
Views: 60,332
Posted By TEV
Re: PUR / Katadyn Watermaker Help from an Ex-Cruiser

From my last post with pic of the cylinder with some pitting, katadyn tech said no problem use 600 grid WD and try remove as much of the pitting as possible - I used 1200 WD and it does look better,...
Forum: Plumbing Systems and Fixtures 13-05-2020, 14:42
Replies: 172
Views: 60,332
Posted By TEV
Re: PUR / Katadyn Watermaker Help from an Ex-Cruiser

In continuation of questions, I am in the process of rebuilding both a PUR80 and PUR80II that were installed by the PO. Having no idea of the condition or numbers of hours in lieu of attempting to...
Forum: Plumbing Systems and Fixtures 22-04-2020, 21:19
Replies: 5
Views: 317
Posted By TEV
Re: External Tank Gauges

I have a Gobius tank gauge for plastic holding tank, simple install and works well.
Forum: Marine Electronics 05-04-2020, 14:02
Replies: 7
Views: 698
Posted By TEV
Re: Need 16ga duplex tinned shielded wire

Thanks I didnít find it on genuinedealz but will order from Pacer.
Forum: Marine Electronics 05-04-2020, 13:44
Replies: 7
Views: 698
Posted By TEV
Re: Need 16ga duplex tinned shielded wire

Thanks! I was too focused on marine
Forum: Marine Electronics 05-04-2020, 12:17
Replies: 7
Views: 698
Posted By TEV
Need 16ga duplex tinned shielded wire

Having tough time locating tinned 16gauge duplex with shield for hailer installation. I can go to 14 gauge but not needed and prefer leave extra space in mast conduit. Any suggested suppliers?
Forum: Marine Electronics 01-01-2020, 20:25
Replies: 8
Views: 930
Posted By TEV
Re: Looking for opinions on cpt autopilots

I have one on a '84 Mariner Neptune 41, 14 tons, we have had the boat 6 years and before us it had cruised Mexico extensively for many years with this autopilot. It worked when we purchased boat but...
Forum: Plumbing Systems and Fixtures 15-09-2019, 19:30
Replies: 21
Views: 1,766
Posted By TEV
Re: Leaking stainless steel tank

I have '84 cruising boat with 70 & 130 gallon built in SS tanks would have to gut the boat to replace. Started leaking last year and after research, talking with top local boat repair guy it came...
Forum: Engines and Propulsion Systems 01-04-2019, 09:08
Replies: 3
Views: 405
Posted By TEV
Re: Lehman 4D61 compression

Thanks I'm going with that. Yeh it seemed crazy Lehman put that compression in the original owners manual it's not possible with that engine.
Tom
Forum: Engines and Propulsion Systems 31-03-2019, 21:33
Replies: 3
Views: 405
Posted By TEV
Lehman 4D61 compression

I'm in process of rebuilding cylinder head after gasket leak, appears caught it early no damage. Question is about compression for the Lehman 4D61 as the Lehman manual has 568psi and the Peugeot...
Forum: Electrical: Batteries, Generators & Solar 30-01-2019, 21:14
Replies: 24
Views: 1,532
Posted By TEV
Re: Help locating analog voltmeter

Len hit it right on point why I wanted to keep an analog meter. I didn't mention as I was looking for analog meter only, is that I actually already have three digital meters reading my batteries, one...
Forum: Electrical: Batteries, Generators & Solar 29-01-2019, 21:37
Replies: 24
Views: 1,532
Posted By TEV
Re: Help locating analog voltmeter

Thanks for all of your input you've definitely provided new options and a good variety.
Forum: Electrical: Batteries, Generators & Solar 29-01-2019, 12:00
Replies: 24
Views: 1,532
Posted By TEV
Re: Help locating analog voltmeter

Thanks, already researched them and voltage range is too broad with meters starting at zero, also they typically have range 0-15 or 0-30 and when my solar panels are going through different charge...
Forum: Electrical: Batteries, Generators & Solar 29-01-2019, 10:33
Replies: 24
Views: 1,532
Posted By TEV
Re: Help locating analog voltmeter

Thank you for the lead, maybe I should clarify I can find gauges similar size but not with a scale same or similar to 10-16, a 90 degree scale 0-16 is not accurate enough.
Thanks
Forum: Electrical: Batteries, Generators & Solar 29-01-2019, 09:37
Replies: 24
Views: 1,532
Posted By TEV
Help locating analog voltmeter

I have been searching with no luck for a replacement voltmeter with the same dimensions as the meter removed as there is a hole in my panel 2-1/2" diameter and meters I find such as Blue Seas have a...
Forum: Monohull Sailboats 21-10-2018, 20:32
Replies: 1,872
Views: 495,660
Posted By TEV
Re: Boats Less Than $30K Recent Noteworthy Finds

Thanks Ann for the info I will see how it goes, I have a couple people that are showing interest in bringing her back to life. Plan to get back to the boat hopefully this week and start engine (as...
Forum: Monohull Sailboats 19-10-2018, 15:29
Replies: 1,872
Views: 495,660
Posted By TEV
Re: Boats Less Than $30K Recent Noteworthy Finds

Hi all,
Came across this thread and thought I would throw out this opportunity FREE Hans Christian 38T 1976. My father inlaw has been removed from his boat due to dementia, he did a single handed...
Forum: Deck hardware: Rigging, Sails & Hoisting 08-10-2018, 20:47
Replies: 34
Views: 5,112
Posted By TEV
Re: Stainless steel shackle corrosion

I just bought 5/16" peerless high strength galvanized anchor shackles for a section of 1/4" G43 chain. So they are available.
Forum: Marine Electronics 29-07-2018, 21:23
Replies: 7
Views: 684
Posted By TEV
Re: Raymarine i70

I have a set in the cockpit and at nav station, depth, wind, AIS, etc setup on each. Work great!
Forum: Auxiliary Equipment & Dinghy 25-02-2018, 19:28
Replies: 16
Views: 2,015
Posted By TEV
Re: What is it?

I have one fits the windlass but requires removal of top brake handle section to fit. Manuals are online. Have fun.
Forum: Plumbing Systems and Fixtures 13-03-2015, 11:08
Replies: 172
Views: 60,332
Posted By TEV
Re: PUR / Katadyn Watermaker Help from an Ex-Cruiser

Hi, I've tried emailing Gary with questions and also no reply. Hope all is well.
Showing results 1 to 22 of 22

 
Forum Jump


All times are GMT -7. The time now is 21:00.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2020, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.