Cruisers Forum
 

Go Back   Cruisers & Sailing Forums > Search Forums
Reload this Page Search Results
Cruiser Wiki Click Here to Login
Register Vendors FAQ Community Calendar Today's Posts Log in

Showing results 1 to 15 of 15
Search took 0.00 seconds. Search: Posts Made By: tailgnner32
Forum: Engines and Propulsion Systems 30-07-2020, 11:05
Replies: 22
Views: 5,700
Posted By tailgnner32
Re: Yanmar 2GM20F - treatment for blowby

All great ideas but I would check the mixing elbow. If you have the U-type elbow, it's only good for 4 to 5 years tops, if could be causing back pressure if it's plugged.
Forum: Engines and Propulsion Systems 10-12-2019, 13:18
Replies: 17
Views: 50,948
Posted By tailgnner32
Re: Perkins spin-on fuel filter adapter - Foley

Try Complete Yacht Service in Fort Lauderdale, they are Perkins, and Yanmar dealers, there the the guys that invented it about 40 years ago, and they stock them.
Forum: Engines and Propulsion Systems 31-10-2019, 09:05
Replies: 8
Views: 1,741
Posted By tailgnner32
Re: Yanmar parts manual - what does I and R stand for.

In your case the R stands for remarks. It's telling you that the part number
was changed after serial # E25450. The new number for the freshwater should
be 129470-42002
Forum: Engines and Propulsion Systems 14-08-2019, 09:21
Replies: 12
Views: 10,929
Posted By tailgnner32
Re: Replace Yanmar Instrument Panel Type C

I know Complete Yacht Service in Fort Lauderdale Fl.
Has the lables for the B and C-Panels, not sure about
the panels
Forum: Engines and Propulsion Systems 26-03-2019, 09:20
Replies: 5
Views: 1,640
Posted By tailgnner32
Re: Does the Perkins 6.3544 have zincs in the heat exchanger?

The Perkins 6-354.4 does not have an engine zinc installed by Perkins.
If your engine has an air charge cooler, there's a drain valve in the
rear cover, you can remove this drain valve and install...
Forum: Engines and Propulsion Systems 08-03-2018, 08:30
Replies: 10
Views: 4,931
Posted By tailgnner32
Re: perkins 6354 low oil pressure

If that does not fix it, keep in mind it could also be the seal in the injection pump. That's the only two places you can get fuel in the sump.
Forum: Engines and Propulsion Systems 05-03-2018, 12:12
Replies: 13
Views: 5,707
Posted By tailgnner32
Re: Yanmar 3GM30 Starter Solenoid

X211447009 is correct, but that's the old #. and will work as well.
X2114T7013 is the new. Yanmar is always changing part numbers.
Forum: Engines and Propulsion Systems 05-03-2018, 10:39
Replies: 13
Views: 5,707
Posted By tailgnner32
Re: Yanmar 3GM30 Starter Solenoid

Supposed to fit? Try it.
Forum: Engines and Propulsion Systems 05-03-2018, 08:40
Replies: 13
Views: 5,707
Posted By tailgnner32
re: Yanmar 3GM30 Starter Solenoid

The part number for the starter solenoid is X2114T7013 sells for about $105.00, and you will have to remove the starter to install it.
Forum: Engines and Propulsion Systems 22-01-2018, 10:12
Replies: 13
Views: 5,575
Posted By tailgnner32
Re: Perkins 4108 injection pump

Not always will the timing marks line up on a 4-108, most of the time they wont. The Perkins 4-108 injector pump almost always need a little tweaking.
If your getting a little white smoke out of the...
Forum: Engines and Propulsion Systems 26-10-2017, 09:14
Replies: 5
Views: 1,261
Posted By tailgnner32
Re: seeking info on 3 cyl Yanmar

With the E in the serial number, and being a 3 cylinder it
is going to be a 3gm30, or a 3ym30. Call Mark with Complete Yacht Service,
they are in Fort Lauderdale and can send parts to your friend....
Forum: Engines and Propulsion Systems 20-09-2017, 06:57
Replies: 28
Views: 8,426
Posted By tailgnner32
Re: Perkins 4108 fuel pump anti stall device

On a Perkins 4-108 you never bleed that top bleed screw, just for this reason,
you only bleed from the screw on the side of the pump, don't believe everything you read. Maka is right, the anti stall...
Forum: Engines and Propulsion Systems 18-08-2017, 05:38
Replies: 18
Views: 9,601
Posted By tailgnner32
Re: Yanmar fresh water pump

Thank You, Gord May!
Forum: Engines and Propulsion Systems 18-08-2017, 05:26
Replies: 18
Views: 9,601
Posted By tailgnner32
Re: Yanmar fresh water pump

Sorry my post is a day late, 728695-43500 is the body between the f/w pump
and the engine block, that should be fine, but the price on that pats is $167.64
If you feel you need that as well, you...
Forum: Engines and Propulsion Systems 16-08-2017, 07:05
Replies: 18
Views: 9,601
Posted By tailgnner32
Re: Yanmar fresh water pump

Yanmar no longer sells rebuild kits for that fresh water pump.
The Yanmar part # for the pump is 121000-42100 $108.10
The part # for the gasket is 121000-42051 $3.71. That pump will fit both the ...
Showing results 1 to 15 of 15

 
Forum Jump


All times are GMT -7. The time now is 03:19.

Contact Us - Cruisers & Sailing Forums - Sitemap - Community Rules - Terms of Service - Privacy - Accessibility - Top

Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
close

Privacy Guaranteed - your email is never shared with anyone, opt out any time.


ShowCase vBulletin Plugins by Drive Thru Online, Inc.