|
Click Here to Login |
Community Links |
Social Groups |
Pictures & Albums |
Members List |
Meet the Mods |
Meet the Advisors |
Signup for The Daily Cruiser Email |
Search Forums | |||||
Tag Search | |||||
Advanced Search |
Showing results 1 to 25 of 89
Search took 0.01 seconds. Search: Posts Made By: alamoana |
Forum: Construction, Maintenance & Refit 18-09-2023, 08:38 |
Replies: 9
Views: 888
Posted By
alamoana
Re: Blisters again
I would buy a peeler, make DIY hotvac, buy a warm pressure washer and a moisture meter, Peel gel coat, wash daily with warm water AM and PM. Measure humidity weekly until it starts to come down, then... |
Forum: Engines and Propulsion Systems 25-07-2023, 14:54 |
Replies: 44
Views: 2,859
Posted By
alamoana
|
Forum: General Classifieds (no boats) 13-07-2023, 11:13 |
Replies: 3
For Sale: Lofrans Tigres Horizontal Windlass
Views: 1,381
Posted By
alamoana
|
Forum: Plumbing Systems and Fixtures 04-07-2023, 09:06 |
Replies: 8
Views: 925
Posted By
alamoana
|
Forum: Engines and Propulsion Systems 23-05-2023, 06:20 |
Replies: 135
Views: 10,612
Posted By
alamoana
Re: Outboard decisions: 2 vs 4 strokes
I would choose the 15 HP because you need it with 4 passengers. I would choose 4 stroke because you can fresh water rinse it on davits without starting it. The difference is only 400 euro and you do... |
Forum: Anchoring & Mooring 23-05-2023, 06:12 |
Replies: 21
Views: 2,800
Posted By
alamoana
Re: What's the problem with my windlass?
Check the carbon brushes, clean the dust or replace them. Good luck |
Forum: Electrical: Batteries, Generators & Solar 16-05-2023, 18:17 |
Replies: 23
Views: 2,182
Posted By
alamoana
Re: Need a new alternator
I used a Prestolite 8MR alternator 90 Amps or 110 Amps,,for 20 years and never had an issue with them. They were externally regulated by an Amplepower SARV3. Good luck |
Forum: Electrical: Batteries, Generators & Solar 01-05-2023, 06:11 |
Replies: 10
Views: 716
Posted By
alamoana
Re: AGM batteries discharged over winter down to 8V or less. Damaged??
Charge them at a low rate and see what happens…they just might be ok! Good luck |
Forum: Engines and Propulsion Systems 09-04-2023, 15:03 |
Replies: 9
Views: 1,351
Posted By
alamoana
|
Forum: Deck hardware: Rigging, Sails & Hoisting 23-03-2023, 08:35 |
Replies: 8
Views: 853
Posted By
alamoana
Re: Outhaul on cruising cat
If you want to get the most out of your cat, you need an outhaul control where you can use it. You may decide not to tweak it… |
Forum: Multihull Sailboats 11-03-2023, 17:49 |
Replies: 39
Views: 5,487
Posted By
alamoana
Re: Cat Purchase- World Circumnavigation Trip
Most cats I that size range will fit the bill. I would set a budget and stick to it, and find a boat for that price. Good luck |
Forum: Construction, Maintenance & Refit 28-02-2023, 12:06 |
Replies: 11
Views: 1,199
Posted By
alamoana
Re: Has anyone have experience with Oil Leak Stop additives?
I would not go crazy about it. I would repair of when possible. A small leak will not be an issue as long as the oil is topped up. Good luck |
Forum: Engines and Propulsion Systems 16-02-2023, 18:31 |
Replies: 13
Views: 3,189
Posted By
alamoana
Re: Volvo penta MDI Box
I went through 7 boxes all under warranty and they swapped the whole deal for a different brand of electronics (it is in the forum somewhere). If I was in your situation I would go the old way, with... |
Forum: Electrical: Batteries, Generators & Solar 16-02-2023, 07:44 |
Replies: 34
Views: 4,155
Posted By
alamoana
Re: Small genset or additional fuel tank?
I think that 550 AH batteries will rarely take over 50 Amps at 14 V = 700 watts = 1 HP plus inefficiencies, ń will pull 2 HP. Without AC I would not put a genset nor a wind generator. I would... |
Forum: Deck hardware: Rigging, Sails & Hoisting 30-01-2023, 05:36 |
Replies: 1
Views: 405
Posted By
alamoana
Re: Leisurefurl + rope vang = snapped bale?
Nothing is impossible….15 years is forever in boating terms, good luck! |
Forum: Electrical: Batteries, Generators & Solar 05-01-2023, 08:17 |
Replies: 50
Views: 7,637
Posted By
alamoana
Re: Water Maker
With all those appliances you will do well with a genset. You may replace a genset with a LARGE inverter and MANY panels but even so, it will be easier with a genset. I was in a similar situation and... |
Forum: Multihull Sailboats 01-12-2022, 17:00 |
Replies: 10
Views: 860
Posted By
alamoana
Re: Airlock in raw water cooling.
Happened to me too…the strainer lid was not closing properly. A little Vaseline on the Oring and care when closing the lid fixed it. Good luck |
Forum: Privilege Marine Catamarans 01-12-2022, 06:08 |
Replies: 401
Views: 133,784
Posted By
alamoana
Re: Privilege Cats
I swapped to VP D2-55 with saildrives from the MD2030. A huge improvement, cruise at 8.5 and max 9.5 kts |
Forum: Electrical: Batteries, Generators & Solar 03-11-2022, 17:54 |
Replies: 80
Views: 17,950
Posted By
alamoana
Re: Alternator cooling
The Lithium bank accepts a lot of Amps, but do you need 200 Amps? 200 A is serious current and you can do a lot of damage with any loose connections, etc. I was there with a 1100 AH FLA bank, not... |
Forum: Propellers & Drive Systems 11-09-2022, 20:14 |
Replies: 38
Views: 4,431
Posted By
alamoana
Re: Autoprop
What are you trying to achieve? An aluminum fixed 3 Blade prop is cheap and fine to some…others use a 2 bladed folding prop, some feathering, others folding ones. For what boat? What engine do you... |
Forum: Anchoring & Mooring 15-08-2022, 17:18 |
Replies: 36
Views: 6,505
Posted By
alamoana
Re: How to size the thickness/strength of a bridle
48’ cat with 3/8” G43 chain, Rocna 70#, 5/8” Octoplait nylon bridle that broke once, swapped the 5/8” for same. I do have a 3/4” octoplait bridle for stronger winds. I believe you are fine. Like... |
Forum: Propellers & Drive Systems 22-06-2022, 19:43 |
Replies: 47
Views: 5,373
Posted By
alamoana
|
Forum: Multihull Sailboats 18-06-2022, 07:52 |
Replies: 57
Views: 6,959
Posted By
alamoana
Re: Beaching small multihulls for service
Yes, you can beach that P37. Just center your weight and have a piece of wood you can attach to avoid it nose diving in case there is too much weight forward. I would dive the area to avoid sharp... |
Forum: Electric Propulsion (EP) 08-06-2022, 09:45 |
Replies: 194
Views: 21,729
Posted By
alamoana
Re: Going electric - change my mind
Before spending that amount of money I would try to solve the current engine problem, but then I look for difficult projects! |
Forum: Engines and Propulsion Systems 08-06-2022, 07:40 |
Replies: 14
Views: 1,634
Posted By
alamoana
Re: Yanmar 3gm35h problems
I would chase the problem with an IR temperature gun if available. You will find it fast. Good luck |
Showing results 1 to 25 of 89 |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc. |
Privacy Guaranteed - your email is never shared with anyone, opt out any time.