Cruisers & Sailing Forums - jreiter190's Album: KAREN

Cruisers Forum

KAREN

Red Seahawk Tropicoat. Changed old A4 1/2" through hull to 3/4" to feed Kubota diesel

In the slings at Eau Galle Yacht Basin, Melbourne. First travel lift I've seen on rails. Note the old slip way on left.

Front view of sail cover and cowlings.The old bow pulpit makes a great butt/belaying /hand hold rail at the perfect height for going forward

Down in about half a minute

Spray dodger up

Aluminum cowlings lift off base and can be rotated 90 or 180 degrees

Finally got some primer on the decks and cabin. Interlux high gloss is next. Next spring, the top sides.

Waterline Marina, Melbourne, Fl. Nice end tie on old wood dock that was falling apart. Very private, but had 8' trailer with 2 new dock boxes,...

Pearson Albergs are long lived and bullet proof because the hull is 1"thick pure cloth and resin; no chop, no filler, just guys inside the mold with...

Folding steps with sets of parallel steps at the spreaders and masthead make working aloft as well as lookout at the spreaders easy for active...

The dead lights in the main cabin were crazed and the aluminum trim rings were,in places, broken. Smoked ovals cut 1" larger than the openings will...

Welcome aboard, partner. She's a work in progress, and I've spent the last few years living in the middle of a construction project . But she's...

KAREN, 1965 Alberg 35. Hull number 190 of 280.Won 1965 Mackinac. D.Q.due to ad measurement glitch. Participated in next four Macs,trucked from...

Made new mahogany washboards that slide in behind this cut down teak door for ease of ingress/egress and double protection in heavy weather. A sea...

Blackout hatch in aft bulkhead of cabin makes great pass through from galley and massive ventilation. To stbd. of teak door.. Saturn bulkhead...

I'm Charlie, Ship's Cat, and if you can do this, Senorita, WELCOME ABOARD! Never cared for full width dodgers. When I first delivered boats up...

New risers with aluminum treads,new teak and holly cabin sole,new engine box. Ladder hinges fwd. and rests on edge of table for access to engine...

Custom aluminum taffrail,holds two outboards, stern hook, swim ladder, stern light. Flagpole holder doubles as Fishing rod holder.Powder Coated. Made...

This is a sail cover that I had made to my own design. It has no metal 1/4 turns, rather loops and toggles and uses a top to bottom zipper with a...

The cowlings over the hatches are made of powder coated aluminum. They have slide in screens that are sandwiched between aluminum frames and the...

Last of 29 deck repairs. The liner makes letting in Dutchman easy. Cut out to dry material, glass in the balsa core and fill voids with epoxy. ...

All times are GMT -7. The time now is 15:06.

Social Knowledge Networks

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.