HilleRange Kerosene Manual

[clausont]

I have a HilleRange kerosene three burner stove with oven that I recently purchased. I have not yet installed it but I did hook it up and give it a try.
It seems to be in pretty good shape and seems to operate correctly, but my problem is that I am just guessing at how to operate it and preheat the burners.
Does anyone have a manual (online or electronic would be great!) for this stove? Or barring a manual, some advice on how to properly operate it?
As mentioned, it seems to operate correctly with regard to fuel delivery and control valve operation etc.
Not knowing the proper pressure to run it at and not knowing the proper method of preheating the burners, I think I would be a little foolish to install it in the boat and then try to learn to use it properly. Right now, it is in my shed with plenty of room around it and nothing flammable near it so it should be pretty safe for me to give it a few practice runs.

[GordMay]

We have a series of links to On-Line SHOP MANUALS, filed under “Construction, Maintenance & Refit” at:
http://www.cruisersforum.com/forums/f55/line-shop-manuals-8758.html
Where you’ll find a link to HILLERANGE / PRINCESS LPG STOVES at:
http://www.cncphotoalbum.com/technical/hillerange_stove/
Hope this helps

[clausont]

Thanks Gord. I was looking for info on the Kerosene model. LPG of course is a different critter. Thanks for the try though.
BTW - The link that you sent went to the ST-60 - not the stove (just for info)

[Dixey]

Originally Posted by clausont

I have a HilleRange kerosene three burner stove with oven that I recently purchased. I have not yet installed it but I did hook it up and give it a try.
It seems to be in pretty good shape and seems to operate correctly, but my problem is that I am just guessing at how to operate it and preheat the burners.
Does anyone have a manual (online or electronic would be great!) for this stove? Or barring a manual, some advice on how to properly operate it?
As mentioned, it seems to operate correctly with regard to fuel delivery and control valve operation etc.
Not knowing the proper pressure to run it at and not knowing the proper method of preheating the burners, I think I would be a little foolish to install it in the boat and then try to learn to use it properly. Right now, it is in my shed with plenty of room around it and nothing flammable near it so it should be pretty safe for me to give it a few practice runs.

I realize that it's been a while since this origninal message was posted, but I've just launched my Ingrid 38 (cutter - long bow sprit) after a complete refit which took 8 years, and have one of the HilleRange 3 burner stove/ovens on board. Is there any chance that you could send me a copy of the manual? I don't have the model number at hand, but it will be better than what I have - nothing.

[GordMay]

Greetings and welcome aboard the CF, Dixey.

See ➥ http://www.catalina27.org/Clips/PRIC...L%20STOVES.pdf