Boat: Murray 33-Chouette & Pape Steelmaid-44-Safara-both steel cutters
I put down some treadmaster, 8 pieces each about 1 foot by 3 feet. I did this about 3 months ago, then left. Now that I am back a couple of the pieces have a blister or two. Apparently I was stingy with the epoxy.
Any suggestions on how to repair short of rip up and start over?
Mask entire top off, inject with epoxy, then vacuum bag. Make sure everything inside the bag is well masked for squeezeout. Use thinned epoxy and a needle for injection. Done right it should only leave the needle hole full of epoxy. If you can't bag it, use something flat with weight on it.
__________________ O you who turn the wheel and look to windward,
Consider Phlebas, who was once handsome and tall as you.