Cruisers Forum
 


Reply
  This discussion is proudly sponsored by:
Please support our sponsors and let them know you heard about their products on Cruisers Forums. Advertise Here
 
Thread Tools Search this Thread Rate Thread Display Modes
Old 07-08-2011, 11:04   #1
Registered User
 
Herbseesmoore's Avatar

Join Date: Apr 2008
Location: Silver Creek, WA, US
Boat: searching
Posts: 215
Images: 10
Anemometer Not Spinning

have volunteered to go up the mast for a fellow sailor here in Sullivan Bay.

What is the #1 reason an anemometer stops spinning, worn out, (must replace), needs lubricate, (any recommendations),

thought it might be helpful to know b4 going up what the thoughts/opinions might be.

Thanks
__________________
"When the world was flat as a pancake, Mona Lisa was happy as a clam" J. Prine
Herbseesmoore is offline   Reply With Quote
Old 07-08-2011, 11:09   #2
Registered User

Join Date: Dec 2009
Posts: 2,959
Images: 4
Re: No spin anemometer

I was going to say worn out from spinning. But in Anacortes? Is there wind there?
daddle is offline   Reply With Quote
Old 07-08-2011, 11:14   #3
Registered User
 
Vasco's Avatar

Join Date: Apr 2004
Location: Toronto
Boat: CS36Merlin, "La Belle Aurore"
Posts: 7,557
Re: No spin anemometer

Depends on the make. I've seen them stuck because of spider webs! Take it off, take it apart, lube if possible.
__________________
Rick I
Toronto in summer, Bahamas in winter.
Vasco is offline   Reply With Quote
Old 07-08-2011, 13:52   #4
Moderator
 
Jim Cate's Avatar

Join Date: May 2008
Location: cruising SW Pacific
Boat: Jon Sayer 1-off 46 ft fract rig sloop strip plank in W Red Cedar
Posts: 21,198
Re: No spin anemometer

G'Day Herb,

I have had success simply inverting the unit and spraying Inox (Australian spray lube, very low viscosity) around the shaft exit and manually spinning the vanes for a while.

Lacking Inox, I would think that any spray lube (NOT wd-40, which has poor lube qualities) ... ie, Silicone based lubes would likely work as well. The important thing is the low viscosity which helps it get into the area where the little ball bearing lives.

Good luck.

Cheers,
Jim
__________________
Jim and Ann s/v Insatiable II, lying Port Cygnet Tasmania once again.
Jim Cate is offline   Reply With Quote
Old 07-08-2011, 14:07   #5
Registered User
 
senormechanico's Avatar

Join Date: Aug 2003
Boat: Dragonfly 1000 trimaran
Posts: 7,162
Re: No spin anemometer

Quote:
Originally Posted by daddle View Post
I was going to say worn out from spinning. But in Anacortes? Is there wind there?
Heh,

The first time I visited Skyline Marina (before I was an experienced boater) I wondered why so many boats had so many BIG and extra dock lines.
After asking a guy on the dock about it, he said "In winter, we get lots of wind storms over 60 knots."

Since then, I've been in Anacortes when it's blowing stink, with FOG.
That put the old myth to bed for me that you can't have wind and fog at the same time.
__________________
The question is not, "Who will let me?"
The question is,"Who is going to stop me?"


Ayn Rand
senormechanico is offline   Reply With Quote
Old 07-08-2011, 14:24   #6
Moderator Emeritus
 
hummingway's Avatar

Cruisers Forum Supporter

Join Date: Jan 2010
Location: Gabriola Island & Victoria, British Columbia
Boat: Cooper 416 Honeysuckle
Posts: 6,933
Images: 5
Re: No spin anemometer

In the Degnan Bay we have a lot of Purple Martens. They're a lot of fun to watch. They'll sometimes land on wind vanes which can be quite challenging when the wind is shifting! After one had taken a ride on mine I noticed it was stuck and took a good puff from mother nature to free it again. I guessed a poorly placed bird dropping was to blame.
__________________
“We are the universe contemplating itself” - Carl Sagan

hummingway is offline   Reply With Quote
Old 07-08-2011, 14:34   #7
Registered User
 
speciald@ocens.'s Avatar

Join Date: Apr 2008
Location: On the boat - Carib, Chesapeake
Boat: 58 Taswell AS
Posts: 1,139
Re: Anemometer Not Spinning

I've had both spider webs and bird poop stop the spin. Clean and spray with a non-sticky lub like Sailcote.
speciald@ocens. is offline   Reply With Quote
Old 07-08-2011, 20:27   #8
Registered User
 
Herbseesmoore's Avatar

Join Date: Apr 2008
Location: Silver Creek, WA, US
Boat: searching
Posts: 215
Images: 10
Re: Anemometer Not Spinning

thanks for the input. went up and removed and while I waited, owner cleaned and lubed, works fine now and a new friend is made. Then another couple needed a dangling antennae attended to so I went up again, more new friends. And so it goes, time for my mast job and discovered the antennae had a funky fitting and would not go with the L bracket, mission scrubbed, beers all around, let the tall tales fly. It was a good day in the Broughtons.
__________________
"When the world was flat as a pancake, Mona Lisa was happy as a clam" J. Prine
Herbseesmoore is offline   Reply With Quote
Old 07-08-2011, 22:40   #9
Moderator Emeritus
 
hummingway's Avatar

Cruisers Forum Supporter

Join Date: Jan 2010
Location: Gabriola Island & Victoria, British Columbia
Boat: Cooper 416 Honeysuckle
Posts: 6,933
Images: 5
Re: Anemometer Not Spinning

You're all the way up in the Broughtons Herb? Nice.
__________________
“We are the universe contemplating itself” - Carl Sagan

hummingway is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Prop Shaft Spinning when Sailing bruadair Propellers & Drive Systems 73 01-09-2011 08:18

Advertise Here


All times are GMT -7. The time now is 16:18.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.