MD30 valve adjust as follows:
- firing order- 1,3,4,2
- clearance, both inlet and exhaust- .4mm or .016”
Remove the valve cover and rotate the engine
clockwise (viewing from the front) until both valves on #1 cylinder are “rocking”....ie. Exhaust
just closing and intake just opening, both valves moving at this point. #1 cylinder is on overlap stroke at this point. Then rotate the crank one full turn more. This puts #1 at TDC compression
. Adjust #1 cylinder valves at this point.
Rotate the crank 1/2 turn and adjust #3-
Rotate the crank another 1/2 turn and adjust #4
Rotate the crank another 1/2 turn and adjust #2
capacity is 15 liter without a hot water heater
. Add extra for hot water heater
and hose length. Mix 50/50 good quality Diesel
with distilled water. Change interval depends on the antifreeze
, but should be every 3-4 yrs.