Hello, I have 2
Rutland 913 units on the stern of our 42ft.
boat. They have been a little
noise so I got some new bearings for them! Now I am in the middle of tearing them down and I can't get the front magnet cover off the bearing. I can not pull the stator and bearing out.
Has anyone had these apart and can give me any
advice? Also I have the
brushes out and they are still 3/4 of an inch long I think they still have a lot of use in them. Also can you tell me how you got the bearings off the shaft?
I have added some photos of my job.
Thank you, Dean