Prosine 2.0 Error Message

[saildad_2000]

I have a Prosine 2.0 inverter\charger connected to 2 banks, 1 house 675 amp AGM (new) and 1 engine start 225 amp AGM (new). I use the Prosine primerarily for inverting and at sea charging from generator. Dockside I use Promariner 1250 to float charge.
While at dock I have repeatedly gotten the error message "int.Temp2TooCold". The manuel suggests raising the ambient temp but the bank is 79 degrees and the temp surrounding the Prosine is above 65. Has anyone had this issue and a suggestion on how to correct it? I realize that clearing the message resets the Prosine.

[Jon D]

Never seen that one I usually get too hot but you can set it up to auto reset after a fault which is what I did. That way takes care of itself.

[btrayfors]

Maybe a bad temp sensor....they vary greatly sometimes, even new ones.

Bill