450: Transom Shower Mixing Tap replacement?

[LeeV]

We have a 2012 450F and there is a leak at the mixing tap on the stbd transom. We thought it was what I've listed below, but the folks at Scandvik said they never supplied Lagoon. Has anybody found replacements, and installed them? We're having a devil of a time figuring out where to start the removal! :-)


Thanks for any leads....

[Bean Counter]

Post a photo of the fitting from outside and from inside engine compartment where hot and cold water pipes join. Might just need a new O ring or seal.

[LeeV]

Here’s what we have. Space behind is limited.

[Bean Counter]

So if it was me, turn off the water supply. Undo the 4 screws on the outside and whole unit should come out, might need to prise off the silcon sealant. Then disconnect the hot and cold hoses and shower hose. Use some cap blanks to seal them off, these are likely a metric thread. Take the unit apart, probably a grub screw that might need some PB blaster, inspect the housing for cracks. Take apart and replace seals/O ring. Reassemble. If the unit is stuffed you might only be able to replace with a US fitting and so need hose end adapters. Take unit to a hardware store that sells both metric and SAE, Fawcetts Annapolis may have something too, and find the bits/adapters that fit, takes the guesswork out.

[Bean Counter]

If you want original it looks like an Osculati, there is a distributor in ME
https://www.osculati.com/en/11135-m-...wer-with-mixer

[LeeV]

Thanks; it turns out their Plastimo; I found them at AhoyCaptain.