Quote:
Originally Posted by Whomda
Can you better describe where you drilled a hole to make the connection? A picture if you don't mind? I'm now in the midst of the same dilemma.
|
To drill a hole in the plastic base plate in the bottom of the
mast requires it to be accessed through the small side
inspection plate towards the base of the
mast. Just get the longest bit you have to fit your drill and skew it in. No room to fit right angle drill adapters, etc. Result is not pretty, but not seen and it gets the job done. Seal after cable is run through with Sika.
Sorry, photographing inside masts is not in my skill set. Good luck and cheers.