Here are the measurements for the receiving fittings on the stern of my Redseal:
The two black loop fittings on the flat upperside of the boat
are 12 14/16 inches apart if measured on center. The inside diameter of each upper loop where the port and starboard top arms of the motor
bracket should insert is 14/16.
The two black loop fittings on the underside of the boat
, angled near the waterline I guess, have somewhat smaller receiving hole diameters of 10/16 or 5/8 as best I can measure. The spread between these two fittings is 9 7/8 inches or 9 14/16 inches on center.
I find no serial
number or date of mfr on the inflatable
but presumably the specifications on all Redseals should be the same, whatever the age.
Does this match up with your bracket? The only information I have other than the name is that the boat is rated for a 4 hp motor which mine is.
If so I will send off a Paypal payment as soon as I hear from you.