Repeater for NMEA2000 and 0183 data.

[Draughty]

Hi all,
My Navman 3100 Repeater has given up after 15 years that I know about; I think 3 before that, so I guess not bad.
What I need ideally is a repeater that will accept 0183 and 2000; 0183 from the existing 3100S depth and log instruments, and 2000 from the Simrad IS20 wind I installed a couple of years ago to replace the 3100S Wind.

Does anyone know if such a thing is available?

(there are various reasons why I would like to keep the existing three instrument display over the companionway, rather than go to an MFD which would have to be at the pedestal)

Thanks

[Sea-TechSystems]

You could use an Actisense NGW-1-ISO to convert from NMEA0183 to NMEA2000 (or the other way) to bring the NMEA0183 data onto your NMEA2000 network, and then add any NMEA2000 displays you want.

[smac999]

^this is the way I'd do it.

do you have several nmea 183 connections? or does everything join into one already? otherwise you'd need multiple converters or a multiplexer

I don't think any small screens will take both. except for chart plotters. (and even now a lot don't take both)

[Draughty]

Thanks for your responses; been off air a while; if you want to see something really not funny try searching something like "windows 10 where has my wifi gone?"
Back to subject: yes it seems I would need two actisenses or one plus a multiplexer for the two 0183 outputs. Starts to add up.
These instruments (log, sounder and repeater) are currently connected by Navbus; just connect all the blue wires together, all the orange together and off you go. The depth and log also have 0183 outputs and the repeater has 3 x 0183 inputs.
I get the feeling I'm going to go without the repeater until something I really need fails and I have to go 2000.

Rgds