Hello CF,
I just re-installed my JRC 1000
radar after it sat in
storage for a few years. It was working fine when removed.
Unfortunately the moron that I hired to rewire my
boat decided he should cut all the control
cables to all the
electronics during the process and throw away the connector ends. Anyways, I found a replacement cable that the connector was cut and carefully spliced and reassembled.
I just fired it up and I get a "Bearing Pulse Error" message on the
screen after the one minute warm up.
My manual does not have a trouble shooting page and I did an
internet search, but no real results.
JRC says that they no longer support this model.
Does anyone know what this typically means? If I had a
wiring diagram I could at least check that wire for continuity.
Thanks in advance for your
advice.
Jeff