ConnectionRayPilot to raymarine 300

[oceanbarsik]

Good day!

Please tell me how to connect the autohelm SeaPilit limit switches from actuator liner driver SDU III RayPilot Sharp to the course computer Raymarine Type 300?


Boris

[BillKny]

Originally Posted by oceanbarsik

Good day!

Please tell me how to connect the autohelm SeaPilit limit switches from actuator liner driver SDU III RayPilot Sharp to the course computer Raymarine Type 300?


Boris

I think you are asking the impossible.

A Raymarine Type 300 does not use hardwired limit switches and has no provision for connecting them. It uses the continuous analog signal from the rudder position sensor to figure out the limits of travel of the rudder.

[oceanbarsik]

Thanks for your answear. But you dont anderstend my problem. I have the leaner driver from the old SeaPilot Sharp. (SDU II). Inside this devise is two switches that can disconnect motor. And i whant to disconnect course computer Type 300 from leaner driver when rudder going max to one or enother board.
Boris