Barrier Coat Touch Up

[frankv1205]

Anybody have a thought on touching up the barrier coat?
When I was sanding off my old bottom paint I sanded a couple of spots to hard and went through the barrier coat, Is there anything I could use to touch up these spots before I put on my bottom paint? ...Thanks

[Shrew]

Sand the bottom paint down to the barrier coat around the spot where you burned through. Wipe down the area you're going to paint with whatever the barrier recommends to treat the area and remove dust (mineral spirits, etc). Then touch up the spot with a chip brush and a few coats. Finally re-bottom paint.

[slug]

Originally Posted by Shrew

Sand the bottom paint down to the barrier coat around the spot where you burned through. Wipe down the area you're going to paint with whatever the barrier recommends to treat the area and remove dust (mineral spirits, etc). Then touch up the spot with a chip brush and a few coats. Finally re-bottom paint.

No solvent

Only wash with soap and water before touching up the epoxy barrier coat