Holding Tank Monitor

[Hudson Force]

While looking for a holding tank monitor that could keep me informed without any messy and cumbersome intrusion into the tank I selected the "Solo" monitor produced by SCAD Technologiess. www.scadtech.com
The total cost for my system was $156 and the installation was simple.



The display shows 5 intervals of fill volume and a red warning light at full. The attachment of the monitor to the tank is achieved with two adhesive strips and an adhesive sensor unit....


I did have a problem with my set-up procedure in calibraing my tank levels and found that the tech support for this US made product was clear, quick and eager. I have now cycled the use of my tank through half a dozen pump-outs with this accurate system and I am very pleased. The 12VDC power for this unit is "milliamp minimal". Take care and joy, Aythya crew