Hi there!
My
Raytheon NV398 is down and I decided to use my
laptop as a navigational data source to displays in
cockpit (SOG, COG etc.) To do it I need to convert round
Raytheon connector to DB-9 female connector.
Instruction :
https://www.libble.eu/raytheon-nav39...082/?page=0003 (page 10-12)
As it mentioned in instruction of Rytheon NV398 the are two ways data in (with + and - ) and data out (with + and -) but in DB-9 there is only Rx and Tx pin and of course GND. It is not clear. The protocool is the same
NMEA 0183 (in old device and in laptop)
Could someone tell me if it is correct to connect only data in + to Rx and data out + to Tx and GND to GND ON DB-9 connector or I’m wrong?