It's time to change the pull line that rotates the hub of my
Hood Roller Furler. I'm supposed to unscrew a couple a screws on the fitting that fits under the
furler and then that piece drops down so I can get at the line and hole it fits thorough so I can install at the new line.
I take out the screws but the
stainless steel fitting that goes over the central hub won't drop down. I'm guessing it's got a ton of
salt crystals in there that's not allowing it to slide down.
Anyone have a suggestion as to how to get the freed up? I've tried tons of
water to desolve them--no luck. I've put in a lubricant(PB blaster and WD 40) with no luck.
I need some help before the line brakes and i'm up the preverbial creek with no paddle and flogging
sails.
Linear Mode
Recent Discussions