My older boat
is going on the hard
for 4 months of re-fit and repairs
. I have already purchased the Force 10 two propane
2 burner stove/oven. Going through older comments in this forum, a common complaint is the belief that Force 10's don't have sufficient insulation
So I was thinking since I am ripping out the old cabinet, all of it, where the stove
is located, can I not just add insulation
to the sides and back of the stove
to create better performance. It really doesn't matter if the the new cabinet is one inch further out beyound the bulkhead.
Secondly, will this affect performance, improve it, or is insulating a waste of time? I figure the cost is next to nothing.