Visit our Popular Forums

Pirate007 · 02-01-2020, 08:01

New condition, never permanetly installed.

Genuine Whitlock Classic Pedestal table mounting kit includes mounting bracket, support bar, level adjustment, release pin. The bracket attaches to the pedestal column, not on the guard as traditional pedestal tables are. The bracket is angled forward so that the guard is not in the way. May be able to be used on other manufacture pedestals.

Includes:
- White powder-coated aluminum mounting bracket
- Stainless steel support bar
- Quick-release pin to remove from pedestal for storage
- (2) table hinges

Price $125.00 + shipping, or pickup in Palmetto, FL. I will provide shipping cost to your zip code, assume residential delivery, assume ground service.

PayPal to my email address, or cash only.

dlclark · 02-01-2020, 17:48

Do you have mounting instructions? Do the hinges hold the horizontal strut? What holds the U shaped strut ends? Shipping to 55311?

Pirate007 · 03-01-2020, 04:46

Quote:

Originally Posted by dlclark

Do you have mounting instructions? Do the hinges hold the horizontal strut? What holds the U shaped strut ends? Shipping to 55311?

It is very easy to set up, simply mount the white pedestal bracket to the back of the Pedestal using (4) screws with the mounting screws oriented below and pivot rod oriented on the top. The SST (2) brackets slip onto the ends of the SST rod and the other ends are attached to the table with (3) wood screws each. I made (2) bracket (black) pads to adjust the height of the table up slightly to better accommodate the SST U bracket alignment. The U bracket small U slips into the white pedestal bracket notch, the other (2) ends attach to the bottom of the table with your choice of fixture, i.e. saddle clamps, P clamp, wood block(s), etc that suits your specific application. This end must pivot as you raise and lower the table.

The advantage of this type of mount is that is moves the table out a few inches from the pedestal tube or pedestal guard to allow for some clearance room.

I will snap a partial assembled picture and send to you in a PM since I can't edit/include in this posting.

Pirate007 · 03-01-2020, 08:38

I was able to upload the installation example pictures in this thread. Note that for the ends of the U Bracket you will need to determine what is best for your installation, i.e. saddle clamps, P clamp (picture shows a nylon example but should be sst), install teak blocks for the U bracket to wedge into, etc.

Obviously the picture is looking at the bottom of the table and the U bracket not aligned, just taped in place for pictures. There is a leveling screw on the pedestal white bracket to set the fore-aft level. Initial installation should keep the leveling screw mid-position to provide fore-aft up-down alignment as required.