Quote:
Originally Posted by Oceansandmts  For a few small parts and tests, inexpensive film, bleeder, peel-ply, etc would be OK, although they may not work as well, but if you graduate to bigger, more complex parts, you will have enough money in fabric, core and resin, and more than enough of your time in getting it all ready, that you will not want to take chances with anything but the best in film, seal tape, vac pump, etc. A failure of almost any part of the system means you have lost your investment of time and money in the part. I don't want to chance it. Just my opinion after infusing some big, complicated parts. |
Makes perfect sense, however, I don't want to ignor the possibility of there being parallel products that are just a good but not sold under the label of custom specialty (read more expensive).
That said, if there isn't, then there isn't.
Also my previous post should have said peel-ply not separator sheet.
Thanks and your point is well taken.
Extemp.