Cruisers & Sailing Forums - View Single Post

**Boracay** · 11-11-2008, 17:47

A 40' steel boat is a major project. You're looking at 4,000+ man hours and $150k+. I have heard of builders putting 10,000 hours into their boat.
Don't forget that the hull is less than one third of the job.
Getting a nice finish on a steel boat is very time consuming.

A boat already in really good condition is the best way to go but if you really want to get your hands dirty then I'd strongly suggest getting a project fibreglass boat with a sound hull and a good reputation. Look at those around 38' and be prepared to do some extensive rebuilding.

Line up your transport and surveyor before you start looking.

11-11-2008, 17:47	#7
Boracay Moderator Moderator Join Date: Feb 2004 Location: nr Blackwattle Bay,Sydney, NSW, Australia Boat: Steel Roberts Offshore 44 Posts: 1,880	Major project... A 40' steel boat is a major project. You're looking at 4,000+ man hours and $150k+. I have heard of builders putting 10,000 hours into their boat. Don't forget that the hull is less than one third of the job. Getting a nice finish on a steel boat is very time consuming. A boat already in really good condition is the best way to go but if you really want to get your hands dirty then I'd strongly suggest getting a project fibreglass boat with a sound hull and a good reputation. Look at those around 38' and be prepared to do some extensive rebuilding. Line up your transport and surveyor before you start looking. __________________ Rust never sleeps Boracay Blog.