|
Click Here to Login |
Community Links |
Social Groups |
Pictures & Albums |
Members List |
Meet the Mods |
Meet the Advisors |
Signup for The Daily Cruiser Email |
Search Forums | |||||
Tag Search | |||||
Advanced Search |
Showing results 1 to 25 of 188
Search took 0.01 seconds. Search: Posts Made By: Pascals Wager |
Forum: Lagoon Catamarans 15-04-2022, 23:41 |
Replies: 0
Views: 338
Posted By
Pascals Wager
450S engine control cables
Can anyone who has replaced these cables please confirm the length? I believe them to be 11m/36ft and 14m/46ft? Thank you. |
Forum: Electrical: Batteries, Generators & Solar 21-12-2020, 10:26 |
Replies: 14
Views: 1,661
Posted By
Pascals Wager
Re: Quattro AC 2 Out issue
I'm thinking now that the input current limit of 50 amps is too high for an 8.5kVA genset. If I reduce it to say 30 amps will the power assist function cover the remaining short term inrush and... |
Forum: Electrical: Batteries, Generators & Solar 21-12-2020, 10:15 |
Replies: 14
Views: 1,661
Posted By
Pascals Wager
Re: Quattro AC 2 Out issue
I get what you're saying but the inrush doesn't exceed the capacity on shore power. This leads me to assume the load side of the circuit is sound as regards cable size and connections. Perhaps... |
Forum: Electrical: Batteries, Generators & Solar 21-12-2020, 09:59 |
Replies: 14
Views: 1,661
Posted By
Pascals Wager
Re: Quattro AC 2 Out issue
The VRM only shows combined AC1 and AC2 OUT, the highest total draw was 8.8 amps. |
Forum: Electrical: Batteries, Generators & Solar 21-12-2020, 06:44 |
Replies: 14
Views: 1,661
Posted By
Pascals Wager
Re: Quattro AC 2 Out issue
Thanks for the replies. I'm happy with the switch over from Shore to Genset and its been functioning for 2 years like that. The water maker is newly installed powered from AC 2 OUT and was tested... |
Forum: Electrical: Batteries, Generators & Solar 20-12-2020, 03:19 |
Replies: 14
Views: 1,661
Posted By
Pascals Wager
Quattro AC 2 Out issue
Quattro is 12/5kW/220. I have both shore power and genset feeding AC 1-IN via a selector switch. On AC 2-OUT I have a water maker with a 1.5kW electric motor. When under shore power all works fine... |
Forum: Lagoon Catamarans 20-07-2020, 10:15 |
Replies: 5
Views: 1,590
Posted By
Pascals Wager
Re: Dual (230/110v) voltage boat ?
My boat is 230V, I have installed a Victron Quattro inverter charger and left the original Christecs in place but have them supplied from a 2nd shore power inlet. They can accept a wide range of... |
Forum: Plumbing Systems and Fixtures 21-04-2020, 22:45 |
Replies: 24
Views: 5,748
Posted By
Pascals Wager
Re: Boost Pump Recommendation please (Watermaker)
I'm installing a watermaker now and it came with an Everflow EF3000 which is available in the US, 3.0GPM open flow. On another issue, am I correct in assuming that the Pushfit style fittings cant... |
Forum: Engines and Propulsion Systems 15-01-2020, 05:06 |
Replies: 1
Views: 1,414
Posted By
Pascals Wager
Re: Yanmar 4JH57 Fault code
Sorted, I must have knocked the stop button on the engine control... doh! |
Forum: Engines and Propulsion Systems 15-01-2020, 04:33 |
Replies: 1
Views: 1,414
Posted By
Pascals Wager
Yanmar 4JH57 Fault code
Can any one diagnose this code displayed when ECU powered? Some recent alternator work was completed. Thanks.206986 |
Forum: Electrical: Batteries, Generators & Solar 15-01-2020, 03:58 |
Replies: 46
Views: 9,939
Posted By
Pascals Wager
Re: Alternator voltage sense
ROM thanks for the quick reply. I'm still working on the final plan for the mixed battery types. At present they are charging together but all chargers are set to LFP profile. I think final plan will... |
Forum: Electrical: Batteries, Generators & Solar 15-01-2020, 03:01 |
Replies: 46
Views: 9,939
Posted By
Pascals Wager
Re: Alternator voltage sense
ROM as you have your answer i will jump in with a question, I'm adding the MC614 to both my Valeo alternators on my cat. Both engine start batteries AGM, are charged thru an isolator. The house... |
Forum: Lagoon Catamarans 16-12-2019, 19:18 |
Replies: 4
General Info: fusion blueetooth dongle not working
Views: 866
Posted By
Pascals Wager
Re: fusion blueetooth dongle not working
Had the same on my old MS205 before it died. Make sure the firmware is up to date. Also try removing all power to the radio, this is done by momentarily removing the fuse on the back of the head... |
Forum: Lagoon Catamarans 16-12-2019, 19:06 |
Replies: 2
Views: 750
Posted By
Pascals Wager
Re: Cable Lenght of the Bowsprit
I can't give you the actual measurement but I just ordered Dyneema Whisker stays for my 450. They will be 3030mm between load points, if using 12mm pins then 3042mm from pin centre to centre. |
Forum: Lagoon Catamarans 24-11-2019, 23:22 |
Replies: 2
450: Re-doing Countertops
Views: 908
Posted By
Pascals Wager
Re: Re-doing Countertops
We replaced ours 2016 450 but it doesn't have the trim of your model. The big hassle was the original counter top was stuck to the cabinet tops. To remove it I had to break it up into pieces.203703 |
Forum: Lagoon Catamarans 21-11-2019, 03:06 |
Replies: 144
General Info: Lagoon Escape Hatches Falling Out
Views: 40,289
Posted By
Pascals Wager
|
Forum: Lagoon Catamarans 12-08-2019, 09:47 |
Replies: 894
Views: 264,774
Posted By
Pascals Wager
Re: Just signed on a new 450s!
The bow pad eye area is raised so not solid deck. From memory it was all glass, it is flat underneath. I backed then with a 5mm thick stainless round plate and made it slightly smaller in diameter... |
Forum: Lagoon Catamarans 29-07-2019, 08:20 |
Replies: 894
Views: 264,774
Posted By
Pascals Wager
Re: Just signed on a new 450s!
Previous post about bow pad eyes, just cut out the Sika and you can insert the backing plate and nuts without too much hassle. Also the Clutch for the bowsprit down haul, this photo is my neighbours... |
Forum: Lagoon Catamarans 20-07-2019, 12:45 |
Replies: 5
Views: 2,140
Posted By
Pascals Wager
Re: Remove yanmar instrument panel difficult
I am doing some work now on my instrument panel. Not sure if this helps but this is the back of the Yanmar engine control on my 2016 450. Was held in by 4 corner screws and sealant only. 196290 |
Forum: Lagoon Catamarans 20-07-2019, 12:37 |
Replies: 53
General Info: Help/Warning Eno oven is worst
Views: 29,744
Posted By
Pascals Wager
Re: Help/Warning Eno oven is worst
L450 Cat, replaced our ENO oven and stove top with Smeg. Admiral is very happy.196288 |
Forum: Lagoon Catamarans 30-05-2019, 22:19 |
Replies: 15
450: Last 450 hull
Views: 2,591
Posted By
Pascals Wager
Re: Last 450 hull
You forgot no place to mount a bbq. Its a beautiful looking boat, better than the L50 imo. Think Lagoon aimed at the non sailing spouse. |
Forum: Lagoon Catamarans 26-05-2019, 05:14 |
Replies: 4
Views: 2,242
Posted By
Pascals Wager
|
Forum: Lagoon Catamarans 15-05-2019, 06:29 |
Replies: 13
General Info: Inverter by lagoon or aftermarket
Views: 2,044
Posted By
Pascals Wager
Re: Inverter by lagoon or aftermarket
I installed a victron quattro 5k on my 450. Did every thing my self, its achievable with some tech knowledge athough not a lot required. I did it because the lagoon option was too expensive and not... |
Forum: Lagoon Catamarans 15-05-2019, 06:24 |
Replies: 14
440: Lucy in Abu Dhabi
Views: 3,103
Posted By
Pascals Wager
|
Forum: Lagoon Catamarans 04-05-2019, 11:58 |
Replies: 4
Views: 2,242
Posted By
Pascals Wager
|
Showing results 1 to 25 of 188 |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc. |
Privacy Guaranteed - your email is never shared with anyone, opt out any time.