Cruisers Forum
 

External Link Notice

Page Information:

Page Title:
Galvanic Series

Page Description:
Alloys are listed in the order of the potential they exhibit in flowing sea water. Certain alloys may become active and exhibit a potential near -0.5 volts in low velocity or poorly aerated water, and at shielded areas.

This Page is About:
Galvanic Series, Potential

NOTICE: By following the "Continue to External Link" above you will be leaving Cruisers & Sailing Forums web site and entering a web site hosted by another party. Cruisers & Sailing Forums does not have any responsibility for, or control over, any of these sites, their content or their privacy policies. We do not endorse or make any representations about them, or any information, products, or materials found there, or any results that may be obtained from using them. If you decide to access any of the linked third parties, you do so entirely at your own risk.

Other Discussions You Might Enjoy
Thread Thread Starter Forum Replies Last Post
flexible shaft coupling for short shaft melemakani Propellers & Drive Systems 6 22-12-2015 05:16
Minimum Distance Between Cutlass Bearing and Shaft Zinc Han Engines and Propulsion Systems 13 13-07-2014 18:12
Strut, Shaft, Shaft Log, Engine Alignment KestrelBuck Engines and Propulsion Systems 24 03-04-2011 23:14
Where to Put Zinc on Prop Shaft? b-rad Propellers & Drive Systems 11 29-10-2009 22:01
YouTube video on shaft packing 5 " shaft Roy M Propellers & Drive Systems 5 24-07-2008 09:07



All times are GMT -7. The time now is 19:54.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.