Cruisers Forum
 

External Link Notice

Page Information:

Page Title:
1969 Chris Craft Roamer 46 Refit: 1st Galley Plywood Install « 1969chriscraftroamer46

Page Description:
Back when I was first thinking about insulation, I figured I'd get the best bang for the buck with spray foam (R7 per inch) on the hull and cabin top and 1-1/2" thick Buffalo Batt polyester nonwoven fabric (R3) on the backside of each plywood panel that faces the hull. That combination should stop condensation…

This Page is About:

NOTICE: By following the "Continue to External Link" above you will be leaving Cruisers & Sailing Forums web site and entering a web site hosted by another party. Cruisers & Sailing Forums does not have any responsibility for, or control over, any of these sites, their content or their privacy policies. We do not endorse or make any representations about them, or any information, products, or materials found there, or any results that may be obtained from using them. If you decide to access any of the linked third parties, you do so entirely at your own risk.



All times are GMT -7. The time now is 08:34.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.