Cruisers Forum
 

External Link Notice

Page Information:

Page Title:
Blisters Again?: Boat Hull Blisters - by David Pascoe, Marine Surveyor

Page Description:
Hull blistering was not a major problem since the first fiberglass hulls were built in the late 1940's, until the advent of mass production on a large scale beginning around 1970.

This Page is About:
hull blister, boat blister, blister, blisters, blistering, marine survey, yacht survey, marine surveyor, Florida

NOTICE: By following the "Continue to External Link" above you will be leaving Cruisers & Sailing Forums web site and entering a web site hosted by another party. Cruisers & Sailing Forums does not have any responsibility for, or control over, any of these sites, their content or their privacy policies. We do not endorse or make any representations about them, or any information, products, or materials found there, or any results that may be obtained from using them. If you decide to access any of the linked third parties, you do so entirely at your own risk.

Other Discussions You Might Enjoy
Thread Thread Starter Forum Replies Last Post
Where Is the Best Place in the World to Have a Wooden Boat Built - Cheap but Good ? Nikos Baillie Monohull Sailboats 9 20-12-2019 10:49
For Sale: Quality built 58 foot spruce wood mast built and located at Gil's Catamarans GdB Classifieds Archive 1 03-06-2013 21:40
Have You Ever Re-Built a Navtec Hydraulic Backstay ? Doons60 Deck hardware: Rigging, Sails & Hoisting 2 26-04-2010 06:41
Thru-Hulls in Cored Hulls ggray Construction, Maintenance & Refit 7 22-12-2009 08:07
It's Been a Long Ten Years! Esconditas Meets & Greets 8 18-05-2009 10:08



All times are GMT -7. The time now is 16:18.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.