[SOLD] 8mm - 5/16" Navtec Norsman stud fitting

[ejlindahl]

I have a Norseman Navtec fitting that does me no good and its such a beautifully machined piece that I’d hate to see it go to the land fill. $10 plus postage will make it worth my while to send it to you. I don’t know its age but it obviously has never been installed. The label on the package says:

Navtec
N030-M0816 (but the M0816 is crossed out and above it is hand written -1016)
SWGLSS 8mm & 5/16 STUD W/1/2 UNF

The bar code on the label is 64639375170, but this may not be accurate as per the crossed out number on the label.

On the larger threaded cone piece is stamped “8MM NORSEMAN”

Over all length of it screwed together is ~6 1/4” or 16 cm. I measured the dimensions of the parts of it and they are noted on the attached pictures. Interestingly the TPI (threads per inch) count seem to be in inches, my metric jig had them fall between the metric values of 1.25, 1.5 and 1.75 threads per mm. Pictures and dimensions are on my photobucket.

$10 or better/best offer, plus shipping. I think shipping in the USA will be around $5. I am in Seattle, Washington.

[sailnow2011]

pm sent

[sanibel sailor]

I will buy it. 5/16 and 8 mm are essentially identical.

[ejlindahl]

Several have responded and I will likely go with the first one. I'll let you all know if it is still available.

[sailnow2011]

I was first, right?

[ejlindahl]

Yes, Sailnow is first in line. Still need Sailnow's zip code, PM me.