Cruisers Forum
 


Join CruisersForum Today

Reply
 
Thread Tools Rate Thread Display Modes
Old 06-05-2009, 04:47   #1
Registered User

Join Date: Oct 2008
Posts: 205
Velvet Drive trans/Cables

I recenty replaced the shift cable on a Model#71C that is bolted to a Perkins 4.108. The shift handle is a single that controls both gear and throddle. I understand the concept of getting the detwent positioned over the hole in the shift plate. I have the cables set so that even a slight movement puts the hole and the ball in alignment. As the throddle advances, the hole in the plate goes past the ball. I have been told that the hole and the detent (Ball) shoud always be aligned, that there is a stop screw to keep the shift cable from advancing when the throddle is advanced. Right or wrong? Thanks, Bob
__________________
roberttigar is offline   Reply With Quote
Reply

Tags
cables

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Borg Warner Velvet Drive spinning tomrobalo1 Propellers & Drive Systems 10 31-03-2009 21:41
Extending my transducer cables... Boracay Marine Electronics 4 05-08-2008 21:25
4108 & Velvet Drive 1:1 ? S/V Elusive Engines and Propulsion Systems 6 16-03-2008 17:23
Qst - Velvet drive Transmission help appreciated. dkall Engines and Propulsion Systems 3 19-10-2007 13:41



Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -7. The time now is 02:06.


Google+
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2017, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.