Cruisers Forum

Join CruisersForum Today

Thread Tools Rate Thread Display Modes
Old 06-04-2010, 22:55   #31
Do… or do not
s/v Jedi's Avatar

Cruisers Forum Supporter

Join Date: Feb 2009
Location: in paradise
Boat: Sundeer 64
Posts: 9,226
I dunno the water temp down there but it sounds like it all can be done under water. A nice (but temporary until next haul out) fairing can be done using those epoxy sticks. A hack saw will deal with threads sticking out etc.

On turbulence: test it using the engine, increasing speed in steps of 100 rpm's from dead slow to full out and try it on a couple of angles to the waves. The results might just be acceptable until next haul-out.


s/v Jedi is offline   Reply With Quote

thru hull

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
In-Hull Puck Transducer Bright Eyes Navigation 7 09-03-2010 02:21
Removable Through Hull Transducer Waterborn Marine Electronics 0 23-04-2009 19:38
Wind Turbine Mast Design Considerations RBEmerson Electrical: Batteries, Generators & Solar 9 01-12-2008 08:04
Bronze through hull transducer for steel boat ? ribbony Construction, Maintenance & Refit 3 06-05-2008 12:44
Thru hull transducer Islandmike Construction, Maintenance & Refit 5 23-04-2008 13:08

Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -7. The time now is 17:24.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Social Knowledge Networks
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2018, vBulletin Solutions, Inc.

ShowCase vBulletin Plugins by Drive Thru Online, Inc.